Sierra Wireless manual Dart 300 Specific Commands, AT + Commands

DART 300 Migration Guide Comparative AT Command Reference

4.3. DART 300 Specific Commands

The Plus (+) command set is only available on the new DART 300. The DART 200 uses alternative commands or registers where equivalents exist. This section is provided as a cross reference to the equivalent commands in the older DART 200.

Table 4-7: AT [+] Commands

Command	DART 200	DART 300
+IPR	I/O Port Rate (DTE speed)	I/O Port Rate (DTE speed)
	Supported via the &L command.	Sets the communication speed between the
		host (DTE) and the DART 300 modem.
+WCID	Display the System ID (SPNI).	Display the System ID (SPNI).
	Register S108 contains the current SPNI.	Returns the Service Provider Network
		Identifier (SPNI).
+WPCHAN	Lock Specific Channel	Set Modem Channel
	Supported via the -Lcommand.	Sets channel scanning, or locks to a specific
		channel.
+WPCURNEI	Subscriber Identity	Current NEI
	Supported via the \S? query. The NEI	Returns the NEI (in dotted IP format) pointed
	marked with an asterisk is the current one.	to by +WS176 (Auto-register NEI Index).
		This should be the current, or last registered,
		NEI.
+WPDEREG	Registration Control	De-register
	Supported using \R0.	The NEI indexed by +WS197 (Active NEI
	Also supported indirectly via the H3	Index) is de-registered from the network.
	command.
+WPEID	Equipment Identifier (EID)	Equipment Identifier (EID)
	Supported via the I0 Identification command.	Returns the modem’s unique CDPD
	Also shown by the &V command.	equipment identification code in dotted-
		decimal and Hexadecimal notation.
+WPNEI=<ip>	Personalization	Active NEI Write
	Supported via the \Sn command to set the	Writes the specified IP address to the table
	index (equivalent to +WS197) then the	entry indexed by +WS197 (Active NEI
	personalization mode command	Index).
	^A<ip>/<port> to set the address.
+WPNEI?	Subscriber Identity	Active NEI Read
	Supported via the \S? query. The NEI	Returns the active NEI, in dotted IP format,
	marked with an asterisk is the current one.	from the NEI table as determined by the index
		in +WS197 (Active NEI Index).
+WPNEILIST	Subscriber Identity	NEI List
	Supported via the \S? query. The NEI	Displays the four-entry NEI table, with the
	marked with an asterisk is the current one.	type and status of each.
+WPREG	Registration Control	Register (Manual)
	Supported using \R1.	Registers the NEI entry indexed by
		+WS197 (Active NEI Index) with the
		network.

2110291 Rev 1.0 Page 29