Sierra Wireless 300 Indication RSSI, channel state, registration, Status, and channel number

DART 300 Migration Guide			Comparative AT Command Reference
Table 4-7: AT [+] Commands (continued)
Command	DART 200		DART 300
+WPRSSI	Mean RSSI		RSSI and Channel State
	The mean RSSI is available in register		Returns the current Receive Signal Strength
	S102.		Indication (RSSI), channel state, registration
			status, and channel number.
+WPSPNI=	Restrict Channel Selection		Service Provider Network ID Table Write.
[n[,n[,...n]]]	Uses a combination of the personalization		Sets up to 10 SPNI values in decimal,
	mode command ^I to set the SPNI value(s)		separated by commas.
	and \J2 to enable SPNI matching.
+WPSPNI?	Subscriber Identity		Service Provider Network ID Table Read
	Supported via the \S? query. The SPNI list		Returns the SPNI table.
	is displayed in addition to the NEI table.
+WS<n>=[x]	WS-register Write		WS-register Write
	Not supported. The DART 200 uses only		Sets the contents of the specified +WS-
	S registers.		register (n) to the new value (x).
+WS<n>?	WS-register Read		WS-register Read
	Not supported. The DART 200 uses only		The contents of the specified +WS-register
	S registers.		(n) are returned to the host (DTE) as ASCII
			decimal digits.
+WVCALLERIP	Caller IP		Caller IP
	Supported via the S53 register. This also		Reports the IP address of the currently
	includes the port number.		connected remote terminal. The port number
			is not included.
+WVFRIEND=	Friends Only		Active Friend Write
	Uses the dial directory entered via &Z.		This writes the specified IP address and
	Checking is enabled with S82=1.		optional port to the table entry indexed by
			+WS213 (Active Friend List Index).
+WVFRIEND?	Active Friend Read		Active Friend Read
	The dial directory used for friend list		Returns the IP address and port, in dotted IP
	matching is displayed using &Z?.		format, of the Friend List table entry as
			determined by the index in +WS213 (Active
			Friend List Index).
+WVFRIENDLIST		Active Friend Read	Friend List
		The dial directory used for friend list	Displays the current ten-entry Friend List
		matching is displayed using &Z?.	table.
+WVRESET	Reboot		Soft Modem Reset
	Supported using the –Rcommand.		Resets the modem to power-up condition.

2110291 Rev 1.0 Page 30