Telular EVDO manual Basic

Voice and Fax Options (SX7T Only)

Basic (cont.)
	Select a configuration for the Phone jack (J1) and the
	Fax jack (J2):
	J1 Voice, J2 Voice to set both jacks for voice calls only
RJ-11 Jack Mode	(default setting).
	J1 Voice, J2 FAX to set the phone jack for voice calls
	and the fax jack to send and receive fax data.
	J1 Voice, J2 Data to set the phone jack for voice calls
	and the fax jack for CSD data calls.
One Minute Alert Beep	Select Enabled to hear a beep once every minute during
	a voice call.
Voice Privacy Tone	Select Enabled to hear an alert tone if Voice Privacy
	encryption is not available during a voice call.
Call Control
Dialtone after Remote Disconnect	Select Enabled to hear a dial tone if a call is terminated
	from the other end.
Auto Send Delay	Delay between when you finish dialing and the call is
	sent; select from 0 to 10 seconds (3 seconds is default).
	Select Enabled to have the SX7T remember numbers
Zero Delay Dialing (EOD)	you have dialed at least twice and send calls to those
	numbers with no delay when you finish dialing.
Glare Control	Select Enabled to enable automatic handling of “call-
	collision” (2 calls coming in at the same time).
	Length of time a dialtone will remain active when the
Dialtone Duration	receiver is off-hook (10–90 seconds) (40 seconds is
	default).
	Length of time the Receiver Off Hook (ROH) tone
ROH Duration	will sound after the dialtone duration is complete
	(10–90 seconds) (40 seconds is default).
Continuous ROH	Select Enabled to allow for continuous ROH tone until
	the unit is returned to the on-hook state.
Exit E911 Mode	Click Exit E911 Mode button to return the unit to normal
	state after an emergency 911 call.

Wi PATHTM SX7 21 User Guide