Using the Voice and Fax Options SX7T Only

Voice and Fax Options (SX7T Only)

Using the Voice and Fax Options (SX7T Only)

The Wi PATH SX7T Voice/Fax/Data terminal lets you use your wireless service provider for voice calling and faxing (similar to standard PSTN telephone operation) in addition to using the Wireless WAN data features.

Note

Before proceeding, please confirm with your wireless service provider that your account has been provisioned for voice services.

Using the Voice Calling Features on Your SX7T

1.To use the SX7T’s voice calling feature, plug an RJ-11 phone cable into the Phone (J1) or Phone/Fax (J2) input on the back panel.

Phone/Fax (J2)

Phone (J1)

2.Connect the other end of the phone cable into your phone’s RJ-11 input jack.

3.Lift the phone handset off the receiver (or press the TALK or ON button on a cordless phone) and listen for a dial tone.

4.If you hear a dial tone, make a call to confirm your service is active.

Your voice service and calling options should be the same as those on your wireless phone.

For additional programming and setup options, please see “Voice/Fax Programming” on page 19.

Note

Your SX7T should be configured to accept voice signals on both the phone and the phone/fax inputs by default.For questions about your voice service, please contact your wireless service provider.

Tip

If you experience a buzzing in your phone’s earpiece, try moving your phone farther away from the SX7T, and make sure the RJ-11 phone cable is routed away from the antennas.

Wi PATHTM SX7

User Guide