Plug and Play, Damper Wire, Use of the Tilt-Swivel

Plug and Play

This monitor complies with the DDC™1 and DDC2B, which are the Display Data Channel (DDC) standards of VESA. When a DDC1 host system is connected, the monitor synchronizes with the V.CLK in accordance with the VESA standards and outputs the EDID (Extended Display Identification) to the data line.

When a DDC2B host system is connected, the monitor automatically switches to the DDC2B communication.

DDC™ is a trademark of Video Electronics Standards Association.

Damper Wire

Using a white background, very thin horizontal stripes on the screen are visible as shown right. These stripes are damper wires. These wires are attached to the aperture grille inside the Trinitron tube and are there to damp vibrations of the aperture grille in order to prevent them from influencing to the picture quality.

Damper wire

Approx. 6 cm

Use of the Tilt-Swivel

	With the tilt-swivel base, this unit can be adjusted to be
	viewed at your desired angle within 90° horizontally and	15°
	20° vertically.	15°
	20° vertically.
	To turn the unit vertically and horizontally, hold it at its	45°
	bottom with both hands.
		45°
		5°

Specifications

Picture tube	0.25 mm aperture grille pitch
	17 inches measured diagonally
	90-degree deflection
Viewable image size	Approx. 327 × 241 mm (w/h)
	(12 7/8 × 9 1/2 inches)
	15.9” viewing image
Resolution	Horizontal: Max. 1280 dots
	Vertical: Max. 1024 lines
Display picture size	Approx. 300 × 225 mm (w/h)
	(11 7/8 × 8 7/8 inches)

Deflection frequency Horizontal: 31.5 to 64 kHz

	Vertical: 50 to 120 Hz
AC input voltage/current
	100 to 120 V, 50/60 Hz, 1.8 A
	220 to 240 V, 50 – 60 Hz, 1 A
Dimensions	406 × 426.5 × 451 mm (w/h/d)
	(16 × 16 7/8 × 17 7/8 inches)
Mass	Approx. 19.0 kg (41 lb 14 oz)

Design and specifications are subject to change without notice.