Compatible Systems A00-1869, Enterprise-8 manual Rack-Mount Brackets

Page 14

Chapter 2 - Mounting Instructions

8

Rack-Mount Brackets

Figure 3. Rack-Mount Brackets

Brackets (shown in Figure 3) are provided for mounting the IntraPort Enterprise-8 in a stan- dard 19-inch equipment rack or a Telco rack. Note that the left bracket features a fold-down shelf which maintains the proper alignment of the brackets in the rack, but does not bear the weight of the unit. The ledges at the bottom of the brackets bear the weight of the unit until it is securely attached to the equipment rack. You will need to provide your own screws or clips to fasten the brackets and mounting ears to the equipment rack.

Image 14

Contents IntraPort Enterprise-8 VPN Access Server Installation Guide Page Command Line Management Network InstallationCompatiView Software Installation Introduction to the IntraPort Enterprise-8LED Patterns and Test Switch Settings Basic Configuration GuideShipping Defaults Appendix a Connector and Cable Pin OutsAppendix F Terms and Conditions IiiLocation of Voltage Switch on the Power Supply IntraPort Enterprise-8 Installation Overview Introduction to the IntraPort Enterprise-8IntraPort Enterprise-8 Manual Overview Few Notes Warranty and ServiceGetting Started Please Read the ManualsSupplied with the IntraPort Enterprise-8 Additional Items Needed for InstallationWhat You Will Need to Get Started Mounting Instructions Placement ConsiderationsSafety Guidelines Changing the Power Supply Voltage Settings Parts and ToolsInstalling Mounting Ears and Handles Installing Mounting Ears for a Telco RackRack-Mount Brackets Rack-Mount BracketsRight Bracket Installation Fastening the Right Bracket to the RackLeft Bracket Installation Fastening the Left Bracket to the RackSecuring the Shelf Lowering the ShelfMoving the Unit into the Rack Moving the Unit into a Standard Equipment RackPlacing the Unit in an Equipment Rack Placing the Unit in a Standard Equipment RackSecuring the Unit to the Rack Securing the Unit to the RackNetwork Installation Physical Connection RequirementsConnecting the Server to the Ethernet Detail of Riop CardsPower Alarm Information Connecting a Management ConsolePowering Up the Server CompatiView for Windows CompatiView Software InstallationInstallation and Operation System RequirementsTransport Protocols and CompatiView Command Line Management Out-of-Band Command Line ManagementSetting Up Telnet Operation IP Settings for Setups in Parallel with a Firewall Basic Configuration GuideEthernet Interface Configuration IP ProtocolIP Settings for Setups Behind a Firewall AppleTalk Protocol Configuring the Server for LAN-to-LAN TunnelsIPX Protocol Suggested for Client Tunnel Configurations Configuring the Server for IP and IPX Client TunnelsRequired for Client Tunnel Configurations VPN User DatabaseRadius Server User Authentication Settings Setting up Radius AuthenticationSetting the IntraPort Enterprise-8 for a Radius Server ACE/Server Settings Setting up SecurID AuthenticationSetting the IntraPort Enterprise-8 for an ACE/Server Saving a Configuration File to Flash ROM Ethernet Interfaces Shipping DefaultsDefault Password IntraPort Enterprise-8 LED Patterns IntraPort Enterprise-8 Switch Settings Appendix a Connector and Cable Pin Outs Pin Outs for DB-25 Male to DB-25 Female Console CableAppendix B Downloading Software From Compatible Systems Appendix C Security Dynamics ACE/Server Information Appendix D Adding or Replacing Riop Cards Removing and Replacing an Riop Card or Cover PlateAppendix E When the Over Temp Light Comes On Replacing or Cleaning the Intraport Enterprise-8 Air FilterAppendix F Terms and Conditions Appendix F Terms and Conditions