Compatible Systems Enterprise-8, A00-1869 manual Securing the Shelf, Lowering the Shelf

Page 17

Chapter 2 - Mounting Instructions

11

Securing the Shelf

Figure 6. Lowering the Shelf

1.Lower the shelf onto the tabs protruding from the right bracket as shown in Figure 6 and use the thumb screws to fasten the shelf to the bracket. The brackets and shelf should look like Figure 6.1 when fully installed.

Figure 6.1. Securing the Shelf

Image 17

Contents IntraPort Enterprise-8 VPN Access Server Installation Guide Page CompatiView Software Installation Network InstallationCommand Line Management Introduction to the IntraPort Enterprise-8Shipping Defaults Basic Configuration GuideLED Patterns and Test Switch Settings Appendix a Connector and Cable Pin OutsIii Appendix F Terms and ConditionsLocation of Voltage Switch on the Power Supply Introduction to the IntraPort Enterprise-8 IntraPort Enterprise-8 Installation OverviewIntraPort Enterprise-8 Manual Overview Getting Started Warranty and ServiceFew Notes Please Read the ManualsSupplied with the IntraPort Enterprise-8 Additional Items Needed for InstallationWhat You Will Need to Get Started Mounting Instructions Placement ConsiderationsSafety Guidelines Parts and Tools Changing the Power Supply Voltage SettingsInstalling Mounting Ears for a Telco Rack Installing Mounting Ears and HandlesRack-Mount Brackets Rack-Mount BracketsFastening the Right Bracket to the Rack Right Bracket InstallationFastening the Left Bracket to the Rack Left Bracket InstallationLowering the Shelf Securing the ShelfMoving the Unit into a Standard Equipment Rack Moving the Unit into the RackPlacing the Unit in a Standard Equipment Rack Placing the Unit in an Equipment RackSecuring the Unit to the Rack Securing the Unit to the RackPhysical Connection Requirements Network InstallationDetail of Riop Cards Connecting the Server to the EthernetPower Alarm Information Connecting a Management ConsolePowering Up the Server Installation and Operation CompatiView Software InstallationCompatiView for Windows System RequirementsTransport Protocols and CompatiView Out-of-Band Command Line Management Command Line ManagementSetting Up Telnet Operation Ethernet Interface Configuration Basic Configuration GuideIP Settings for Setups in Parallel with a Firewall IP ProtocolIP Settings for Setups Behind a Firewall AppleTalk Protocol Configuring the Server for LAN-to-LAN TunnelsIPX Protocol Required for Client Tunnel Configurations Configuring the Server for IP and IPX Client TunnelsSuggested for Client Tunnel Configurations VPN User DatabaseRadius Server User Authentication Settings Setting up Radius AuthenticationSetting the IntraPort Enterprise-8 for a Radius Server ACE/Server Settings Setting up SecurID AuthenticationSetting the IntraPort Enterprise-8 for an ACE/Server Saving a Configuration File to Flash ROM Ethernet Interfaces Shipping DefaultsDefault Password IntraPort Enterprise-8 LED Patterns IntraPort Enterprise-8 Switch Settings Pin Outs for DB-25 Male to DB-25 Female Console Cable Appendix a Connector and Cable Pin OutsAppendix B Downloading Software From Compatible Systems Appendix C Security Dynamics ACE/Server Information Removing and Replacing an Riop Card or Cover Plate Appendix D Adding or Replacing Riop CardsReplacing or Cleaning the Intraport Enterprise-8 Air Filter Appendix E When the Over Temp Light Comes OnAppendix F Terms and Conditions Appendix F Terms and Conditions