Compatible Systems Enterprise-8 manual Shipping Defaults, Default Password, Ethernet Interfaces

Page 35

Chapter 7 - Shipping Defaults

29

Chapter 7 - Shipping Defaults

Default Password

•letmein

Ethernet Interfaces

IP Defaults

•Ethernet 0:0 is on

•Address: 198.41.12.1

•Subnet mask: 255.255.255.0

•Broadcast address: 198.41.12.255

•Mode: Routed

•All other Ethernet interfaces are off

IPX Defaults

•Ethernet 0:0 is on

•Mode: Routed

•802.3 on, autoseeding

•802.2 on, autoseeding

•Type II off

•802.2 SNAP off

•All other Ethernet interfaces are off

AppleTalk Defaults

•Ethernet 0:0 is on

•Mode: Routed

•Phase II on, autoseeding

•All other Ethernet interfaces are off

Image 35

Contents IntraPort Enterprise-8 VPN Access Server Installation Guide Page Introduction to the IntraPort Enterprise-8 Network InstallationCompatiView Software Installation Command Line ManagementAppendix a Connector and Cable Pin Outs Basic Configuration GuideShipping Defaults LED Patterns and Test Switch SettingsIii Appendix F Terms and ConditionsLocation of Voltage Switch on the Power Supply Introduction to the IntraPort Enterprise-8 IntraPort Enterprise-8 Installation OverviewIntraPort Enterprise-8 Manual Overview Please Read the Manuals Warranty and ServiceGetting Started Few NotesSupplied with the IntraPort Enterprise-8 Additional Items Needed for InstallationWhat You Will Need to Get Started Mounting Instructions Placement ConsiderationsSafety Guidelines Parts and Tools Changing the Power Supply Voltage SettingsInstalling Mounting Ears for a Telco Rack Installing Mounting Ears and HandlesRack-Mount Brackets Rack-Mount BracketsFastening the Right Bracket to the Rack Right Bracket InstallationFastening the Left Bracket to the Rack Left Bracket InstallationLowering the Shelf Securing the ShelfMoving the Unit into a Standard Equipment Rack Moving the Unit into the RackPlacing the Unit in a Standard Equipment Rack Placing the Unit in an Equipment RackSecuring the Unit to the Rack Securing the Unit to the RackPhysical Connection Requirements Network InstallationDetail of Riop Cards Connecting the Server to the EthernetPower Alarm Information Connecting a Management ConsolePowering Up the Server System Requirements CompatiView Software InstallationInstallation and Operation CompatiView for WindowsTransport Protocols and CompatiView Out-of-Band Command Line Management Command Line ManagementSetting Up Telnet Operation IP Protocol Basic Configuration GuideEthernet Interface Configuration IP Settings for Setups in Parallel with a FirewallIP Settings for Setups Behind a Firewall AppleTalk Protocol Configuring the Server for LAN-to-LAN TunnelsIPX Protocol VPN User Database Configuring the Server for IP and IPX Client TunnelsRequired for Client Tunnel Configurations Suggested for Client Tunnel ConfigurationsRadius Server User Authentication Settings Setting up Radius AuthenticationSetting the IntraPort Enterprise-8 for a Radius Server ACE/Server Settings Setting up SecurID AuthenticationSetting the IntraPort Enterprise-8 for an ACE/Server Saving a Configuration File to Flash ROM Ethernet Interfaces Shipping DefaultsDefault Password IntraPort Enterprise-8 LED Patterns IntraPort Enterprise-8 Switch Settings Pin Outs for DB-25 Male to DB-25 Female Console Cable Appendix a Connector and Cable Pin OutsAppendix B Downloading Software From Compatible Systems Appendix C Security Dynamics ACE/Server Information Removing and Replacing an Riop Card or Cover Plate Appendix D Adding or Replacing Riop CardsReplacing or Cleaning the Intraport Enterprise-8 Air Filter Appendix E When the Over Temp Light Comes OnAppendix F Terms and Conditions Appendix F Terms and Conditions