Compatible Systems A00-1869 manual IntraPort Enterprise-8 Switch Settings

Page 37

Chapter 8 - LED Patterns and Test Switch Settings

31

IntraPort Enterprise-8 Switch Settings

The switch for Ethernet 0:0 controls the entire device. For example, if you set the switch for Ethernet 0:0 to “3” and download new software to the device, the other interfaces will auto- matically receive the software update from Ethernet 0:0 via the backplane. In general, the only time you should use an individual RIOP card’s switch is when the card is unable to communi- cate with the backplane for some reason.

0Normal Operation

1Unused*

2Unused*

3Run Boot ROM Downloader

4Unused*

5Erase Flash ROM (OS and Configuration)

6Erase Flash ROM (Configuration Only)

7Unused*

8Unused*

9Allow letmein password for 5 minutes after powerup

ΜCaution: Settings marked with an asterisk may erase your Flash ROM. Please do not use these settings without first contacting Compatible Systems’ Technical Support.

Image 37

Contents IntraPort Enterprise-8 VPN Access Server Installation Guide Page CompatiView Software Installation Network InstallationCommand Line Management Introduction to the IntraPort Enterprise-8Shipping Defaults Basic Configuration GuideLED Patterns and Test Switch Settings Appendix a Connector and Cable Pin OutsIii Appendix F Terms and ConditionsLocation of Voltage Switch on the Power Supply Introduction to the IntraPort Enterprise-8 IntraPort Enterprise-8 Installation OverviewIntraPort Enterprise-8 Manual Overview Getting Started Warranty and ServiceFew Notes Please Read the ManualsWhat You Will Need to Get Started Additional Items Needed for InstallationSupplied with the IntraPort Enterprise-8 Safety Guidelines Placement ConsiderationsMounting Instructions Parts and Tools Changing the Power Supply Voltage SettingsInstalling Mounting Ears for a Telco Rack Installing Mounting Ears and HandlesRack-Mount Brackets Rack-Mount BracketsFastening the Right Bracket to the Rack Right Bracket InstallationFastening the Left Bracket to the Rack Left Bracket InstallationLowering the Shelf Securing the ShelfMoving the Unit into a Standard Equipment Rack Moving the Unit into the RackPlacing the Unit in a Standard Equipment Rack Placing the Unit in an Equipment RackSecuring the Unit to the Rack Securing the Unit to the RackPhysical Connection Requirements Network InstallationDetail of Riop Cards Connecting the Server to the EthernetPowering Up the Server Connecting a Management ConsolePower Alarm Information Installation and Operation CompatiView Software InstallationCompatiView for Windows System RequirementsTransport Protocols and CompatiView Out-of-Band Command Line Management Command Line ManagementSetting Up Telnet Operation Ethernet Interface Configuration Basic Configuration GuideIP Settings for Setups in Parallel with a Firewall IP ProtocolIP Settings for Setups Behind a Firewall IPX Protocol Configuring the Server for LAN-to-LAN TunnelsAppleTalk Protocol Required for Client Tunnel Configurations Configuring the Server for IP and IPX Client TunnelsSuggested for Client Tunnel Configurations VPN User DatabaseSetting the IntraPort Enterprise-8 for a Radius Server Setting up Radius AuthenticationRadius Server User Authentication Settings Setting the IntraPort Enterprise-8 for an ACE/Server Setting up SecurID AuthenticationACE/Server Settings Saving a Configuration File to Flash ROM Default Password Shipping DefaultsEthernet Interfaces IntraPort Enterprise-8 LED Patterns IntraPort Enterprise-8 Switch Settings Pin Outs for DB-25 Male to DB-25 Female Console Cable Appendix a Connector and Cable Pin OutsAppendix B Downloading Software From Compatible Systems Appendix C Security Dynamics ACE/Server Information Removing and Replacing an Riop Card or Cover Plate Appendix D Adding or Replacing Riop CardsReplacing or Cleaning the Intraport Enterprise-8 Air Filter Appendix E When the Over Temp Light Comes OnAppendix F Terms and Conditions Appendix F Terms and Conditions