Chapter 8 - LED Patterns and Test Switch Settings | 30 |
Chapter 8 - LED Patterns and Test Switch Settings
IntraPort Enterprise-8 LED Patterns
The IntraPort
ϖNote: Any continuous flashing pattern not noted in this chapter may be caused by a hard- ware failure. Please call Compatible Systems’ Technical Support if your server shows a hard- ware failure.
Over Temp
The server is above the proper operating temperature. The filter needs changing. See
Appendix E for instructions.
Sys Ready
The server booted properly without detecting any failures.
General Indicators
|
|
|
|
|
|
| Ethernet Lights | Load Lights | Indication |
|
|
|
|
|
|
|
|
|
|
|
| 5 flashing | 20 flashing | Server stacks starting up. |
|
|
|
|
|
|
| 3&4 flashing | 40&60 flashing | No OS loaded. Running from ROM. |
|
|
|
|
|
|
| 1&4 flashing | 40&100 flashing | Erasing OS in Flash ROM. |
|
|
|
|
|
|
| 5 flashing | 20,40&60 flashing | Erasing config in Flash ROM. |
|
|
|
|
|
|
| Scanning from the outside toward the center | Flash ROM erase due to switch setting five or six is | |
|
|
|
| complete. Set switch to zero and cycle power. |
|
|
|
|
|
Ethernet Traffic Indicators
TX: Ethernet transmit packet
RX: Ethernet receive packet
Load % Indicators
These lights indicate the load on the encryption coprocessor card.