Compatible Systems Enterprise-8, A00-1869 manual Placing the Unit in an Equipment Rack

Page 19

Chapter 2 - Mounting Instructions

13

Placing the Unit in an Equipment Rack

Figure 8. Placing the Unit in a Standard Equipment Rack

Figure 8.1. Placing the Unit in a Telco Rack

1.Slide the unit back into the rack until the mounting ears are flush with the sides of the rack.

Proper placement in a standard equipment rack should look like Figure 8. Proper placement in a Telco rack should look like Figure 8.1.

Image 19

Contents IntraPort Enterprise-8 VPN Access Server Installation Guide Page Introduction to the IntraPort Enterprise-8 Network InstallationCompatiView Software Installation Command Line ManagementAppendix a Connector and Cable Pin Outs Basic Configuration GuideShipping Defaults LED Patterns and Test Switch SettingsIii Appendix F Terms and ConditionsLocation of Voltage Switch on the Power Supply Introduction to the IntraPort Enterprise-8 IntraPort Enterprise-8 Installation OverviewIntraPort Enterprise-8 Manual Overview Please Read the Manuals Warranty and ServiceGetting Started Few NotesWhat You Will Need to Get Started Additional Items Needed for InstallationSupplied with the IntraPort Enterprise-8 Safety Guidelines Placement ConsiderationsMounting Instructions Parts and Tools Changing the Power Supply Voltage SettingsInstalling Mounting Ears for a Telco Rack Installing Mounting Ears and HandlesRack-Mount Brackets Rack-Mount BracketsFastening the Right Bracket to the Rack Right Bracket InstallationFastening the Left Bracket to the Rack Left Bracket InstallationLowering the Shelf Securing the ShelfMoving the Unit into a Standard Equipment Rack Moving the Unit into the RackPlacing the Unit in a Standard Equipment Rack Placing the Unit in an Equipment RackSecuring the Unit to the Rack Securing the Unit to the RackPhysical Connection Requirements Network InstallationDetail of Riop Cards Connecting the Server to the EthernetPowering Up the Server Connecting a Management ConsolePower Alarm Information System Requirements CompatiView Software InstallationInstallation and Operation CompatiView for WindowsTransport Protocols and CompatiView Out-of-Band Command Line Management Command Line ManagementSetting Up Telnet Operation IP Protocol Basic Configuration GuideEthernet Interface Configuration IP Settings for Setups in Parallel with a FirewallIP Settings for Setups Behind a Firewall IPX Protocol Configuring the Server for LAN-to-LAN TunnelsAppleTalk Protocol VPN User Database Configuring the Server for IP and IPX Client TunnelsRequired for Client Tunnel Configurations Suggested for Client Tunnel ConfigurationsSetting the IntraPort Enterprise-8 for a Radius Server Setting up Radius AuthenticationRadius Server User Authentication Settings Setting the IntraPort Enterprise-8 for an ACE/Server Setting up SecurID AuthenticationACE/Server Settings Saving a Configuration File to Flash ROM Default Password Shipping DefaultsEthernet Interfaces IntraPort Enterprise-8 LED Patterns IntraPort Enterprise-8 Switch Settings Pin Outs for DB-25 Male to DB-25 Female Console Cable Appendix a Connector and Cable Pin OutsAppendix B Downloading Software From Compatible Systems Appendix C Security Dynamics ACE/Server Information Removing and Replacing an Riop Card or Cover Plate Appendix D Adding or Replacing Riop CardsReplacing or Cleaning the Intraport Enterprise-8 Air Filter Appendix E When the Over Temp Light Comes OnAppendix F Terms and Conditions Appendix F Terms and Conditions