MIL-BOOK™
OPERATORS MANUAL
Figure 2-10 EMI Core & Cable
2.4First Time Use
The MIL-BOOK 1000 comes from the manufacturer with a dead battery. The first time you power “On” the MIL-BOOK 1000, you must use the AC adapter along with an outside power source. Once the main battery pack receive a full charge, you can use it to power the MIL-BOOK 1000. For more information about the battery, refer to “Charging the Battery” later in this chapter.
1.Insert the rechargeable battery pack into the battery compartment.
2.Plug the connector from the AC adapter into the external power port on the rear panel of the MIL-BOOK 1000. Now, plug the power cord into the adapter.
3.Plug the other end of the power cord into grounded 3-prong wall outlet of power strip.
4.Turn “On” the MIL-BOOK 1000.
2.4.1 Installing Software Drivers
To take full advantage of the unique features of your computer, some operating systems require custom software, known as drivers, to be installed. If you purchased the computer with Windows pre-installed, TAG may have already installed the drivers. If not, you need to install the drivers using the driver CD supplied with your MIL-BOOK 1000. This section describes how to install the drivers.