TAG 1000 manual Hard Disk Drive Module, Removing a Pcmcia Cards

MIL-BOOK™

OPERATORS MANUAL

Figure 2-7 Removing a PCMCIA Cards

2.3.7Hard Disk Drive Module

To remove and replace the HDD module.

NOTE

Installing or removing a hard disk when the computer is “On” can destroy the system board and hard disk.

1.Turn the MIL-BOOK 1000 “Off”.

2.Loosen the captive screws securing the access door.

3.Use the handle on the access door to carefully pull the HDD module out and away from the MIL-BOOK 1000 (See Fig 2-8).

4.Insert the new Hard module into the slot. Gently push the HDD module in, until it seats firmly in place. Secure the captive screws on the access door. Turn the power back “On” to the MIL-BOOK 1000.

5.If necessary, run the system configuration utility, to set up or make any changes to the HDD drive parameters. See Chapter 3 for details.

- 2-6 -