Optibase quick start Installing an Encoding Module in MGW 2000e, User Authorization

MGW 2000e Quick Start Guide

Installing an Encoding Module in MGW 2000e

Before you start operating MGW 2000e, you have to install one of the encoding modules listed in Table 1.

For instructions on installing encoding modules, refer to chapter 2 in the user manual.

For tables showing where to connect sources, refer to page 17.

User Authorization

MGW 2000e operates from two user platforms. Table 2 illustrates their access authorization and the tasks they can perform. For additional tasks performed by the users, refer to the user manual.

User	Password	Task	Remarks
Administrator	Administrator	Initializes MGW 2000e	Connects via
		via HyperTerminal from	RS-232.
		a separate PC.
		Configures MGW	Connects
		2000e via Telnet from a	through the
		PC in the network.	network
		Operates MGW 2000e	Connects
		using MGW 2000e	through the
		Director.	network.
MGW2000Guest	--	Views the configuration	Connects
		using MGW 2000e	through the
		Director and previews	network.
		content that is being
		encoded.

Table 2: MGW 2000e’s User Profile

Note

•Disconnect the power cable from the power connector prior to performing any task on the MGW 2000e unit.

•Avoid touching inside free slots as this may cause electrical hazards. Touching inside free slots may also damage your MGW 2000e unit.

4