Optibase MGW 2000e quick start Ports Description

Page 23

MGW 2000e Quick Start Guide

Ports	Description

Six slots	Accommodate up to six encoding modules.
Power connector	Connects power cord (90/260V AC).
Power switch	Switches MGW 2000e on and off.

	Table 4: MGW 2000e Rear Panel Interface

Connectors	Description

Audio	Connects analog audio source
COMP.VID	Connects Composite video source
S-VIDEO	Connects S-Video source

LEDs	Functionality

Source	Off	Bad or no video source
	Green	Video source detected

Table 5: MGE-100 and 200 Encoding Module Interfaces

Cable	Description

Video BNC	Connects Composite video source
S-Video MiniDIN	Connects S-Video source
Stereo MiniJack Audio	Connects analog audio source

Table 6: Cables connecting Sources to MGE-100/200 Encoding Modules

17

Image 23

Contents MGW 2000e Trademarks When using MGW 2000e Safety InstructionsPage Page Page MGW 2000e Overview Chassis Components Description MGW 2000e ComponentsUnpacking MGW 2000e Power SupplyGetting Started User Authorization Installing an Encoding Module in MGW 2000eBefore you initialize MGW 2000e Initial ConfigurationTo initialize MGW 2000e To add the required connectionsTo change MGW 2000e’s hostname To define TCP/IP settings If your Network is not Dhcp enabledIf you wish to log on again To display TCP/IP settingsTo log off MGW 2000e Logging on to MGW 2000e Director Transmitting StreamsConfiguring Stream Parameters Configuring a Live ChannelConfiguring Source Parameters Configuring a UDP Target To stop transmitting Running a ChannelTo transmit a stream To preview a MPEG-1 UDP stream Previewing MPEG-1 UDP StreamsLEDs Description Hardware OverviewPorts Description MGE-200D Encoding Module Interfaces Page Page Optibase Inc Software Updates DocumentationTechnical Support Warranty