Optibase MGW 2000e quick start

Page 4

•Keep your MGW 2000e unit away from radiators and heat sources. Also, do not block cooling vents. Avoid placing loose papers underneath your MGW 2000e unit. Do not place your MGW 2000e unit in a closed-in wall unit or on a bed, sofa, or rug.

•When you disconnect a cable, pull on its connector or on its strain relief loop, not on the cable itself. Some cables have a connector with locking tabs; if you are disconnecting this type of cable, press in on the locking tabs before disconnecting the cable. As you pull connectors apart, keep them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, make sure both connectors are correctly oriented and aligned.

•ESD Warning: Normal handling precautions should be taken to avoid static discharge.

Image 4

Contents MGW 2000e Trademarks Safety Instructions When using MGW 2000ePage Page Page MGW 2000e Overview MGW 2000e Components Chassis Components DescriptionGetting Started Power SupplyUnpacking MGW 2000e Installing an Encoding Module in MGW 2000e User AuthorizationInitial Configuration Before you initialize MGW 2000eTo add the required connections To initialize MGW 2000eTo change MGW 2000e’s hostname If your Network is not Dhcp enabled To define TCP/IP settingsTo log off MGW 2000e To display TCP/IP settingsIf you wish to log on again Transmitting Streams Logging on to MGW 2000e DirectorConfiguring a Live Channel Configuring Stream ParametersConfiguring Source Parameters Configuring a UDP Target To transmit a stream Running a ChannelTo stop transmitting Previewing MPEG-1 UDP Streams To preview a MPEG-1 UDP streamHardware Overview LEDs DescriptionPorts Description MGE-200D Encoding Module Interfaces Page Page Technical Support Software Updates DocumentationOptibase Inc Warranty