Chapter 6: Troubleshooting & Tips
Powering the system off and on once to reset the drive. Also confirm that cables are properly attached and the drive is receiving power.
If the drive still appears to have failed, refer to the Rebuilding a logical drive option in the WebPAM software as detailed in the WebPAM User Manual.
Drive cannot be formed into an logical drive
Disk drives must be free of media defects to be added into a logical drive. Promise recommends using new identical disk drives for each logical drive.
System CMOS displays C: or D: drive failure during Startup
Do not reference C: or D: in the Motherboard Standard CMOS for drives attached to the FastTrak controller. Only enter drive information in the Motherboard CMOS for drives attached to the onboard IDE controller.
FDISK reports a much lower drive capacity if a single physical drive or a striped logical drive exceeds 64GB (Windows 2000)
Due to a limitation with FDISK, the utility reports only the storage capacity that exceeds 64GB. This is a cosmetic, not actual, limitation. Simply create a single DOS drive partition, reboot, and then format the partition. The Format command will recognize the total capacity of the partition accurately. Windows will now recognize the total capacity of your logical drive.
Unable to Partition or Format Logical Drive
The MBR of one of the drives has become corrupt. Delete the existing logical drive, then create a new logical drive with the Fast Init feature set to ON.
Cannot Rebuild Mirrored (RAID 1) Array
See Unable to Partition or Format array, above.
Fatal Errors or Data Corruption Are Constantly Reported When Reading or Writing to Drive Array
See Unable to Partition or Format array, above.
Operating System-Related Issues
The Operating System no longer boots after creating a Mirrored Array using your existing boot drive using Windows 2000/XP/2003 Server
This is due to Drive Geometry issues. You can verify this if you move the original drive back to the onboard controller and it boots successfully. Each controller can view a drive differently. This can be an issue for a new controller that loads the original Master Boot Record (MBR) and then has a problem translating it or the Operating System boot record.
53