FastTrak100 User Manual
Installing Drivers with Existing Millennium System
The following section details the installation of FastTrak100 drivers on a system that has Millennium already installed and running. If you’re installing the FastTrak100T M drivers on a system during an installation of Millennium, see “Installing Drivers During Millennium Installation.”
1.After installing the FastTrak100 controller card and configuring the hard drives, power up the system and boot.
2.The “Add New Hardware Wizard” will appear, informing you that it has found a “PCI RAID Controller.”
3.Click on “Next,” and from the generated list box, choose “Search for a better driver than the one your device is using now.”
4.Click on “Next,” and from the generated choices, choose “Specify a location.”
5.Insert the “FastTrak100 Driver” diskette in drive A:.
6.Type “A:\WINME” in the text box that appears.
7.Click on “Next.” A message informing you that Windows Millennium has found “Windows Millennium Promise FastTrak100 Controller” should appear.
8.Click on “Next,” and then on “Finish.”
9.Choose “Yes” when asked if you want to restart your computer. Be sure to eject the diskette from drive A:.
Confirming Driver Installation in Millennium
To confirm that the driver has been properly loaded in Millennium, perform the following steps:
1.Choose “Settings” from the “Start” menu.
2.Choose “Control Panel,” and then
3.Choose the “Device Manager” tab, and then click the “+” in front of “SCSI & RAID controllers.” “Windows Millennium Promise FastTrak100 Controller” should appear.
37