Promise Technology FAST TRAK100TM user manual Installing The Card

FastTrak100 User Manual

Installing The Card

Installing the FastTrak100 controller card in a system is a simple process. The card fits into any available 32-bit PCI slot on the system’s motherboard (see figure below).

1.Remove the cover of your system.

2.Remove the inside slot cover of an available 32-bit PCI slot on the motherboard.

3.Install the FastTrak100 controller card into the open slot (see Figure 1 below).

4.Attach your system case’s 2- or 4-pin LED cable to the LED connector on the FastTrak100 controller card (see figure next page). Make sure that pin 1 on the connector is aligned with pin 1 of the cable.

5.Fasten the controller card bracket to the system case (see below).

Figure 1

7