NCR 7882 manual Mounting RealScan, Rubber Feet, Plastic Top Plate

Page 23

NCR RealScan 7882 Installation and Owner Guide

Step 4 - Mounting the

RealScan 7882

Rubber Feet

The NCR RealScan 7882 Scanner is supplied with rubber feet that can be attached to the sides of the cabinet. This permits the scanner to sit on the checkstand in a vertical position without being mounted to the Vertical Mounting Bracket. There are round recesses in each side of the cabinet that accept the rubber feet. Remove the paper backing from the rubber feet and stick them to the cabinet in the round recesses.

Plastic Top Plate

Your installation may use a Plastic Top Plate. Make sure no rubber feet are attached to the cabinet.

1.Properly align the scanner with the Plastic Top Plate.

2.Fasten the scanner to the Top Plate making sure that all four latches are securely latched around the scanner.

Plastic Top Plate

Scanner

Mounting Latches

18718B

497-0419630 Release F

09/02

23 of 62

Image 23

Contents RealScan Installation and Owner Guide Revision Record ContentsObtaining Technical Assistance Obtaining Additional InformationRealScan RealScan 7882 MountingsStep Installation InstructionsConnecting the Cables to an NCR RealScan Installing Power Supply Interface CablesUSB Interface Connection IBM HID Auxiliary RS-232 Port Auxiliary RS-232 PortProgramming the Communication Parameters Setting Program Parameters and Verifying Host ConnectionTurning on the RealScan RS-232 NCR 2170, 7452 Ocia Short Format NCR 2113, 2126 RS-232 Ruby Verifone Ruby 4M UPC/EAN Programming DefaultsPrefix Byte Disable Ascii Code RS-232 Communications Programming for USB ConnectionMaking Other Program Changes UPC-A Scan Sample Tags1234 5 678 Determining Label QualityScan Zone Adjusting Screw Setting RealScan Scan ZoneVertical Pass-by Scanning Horizontal Pass-by ScanningVertical Presentation Scanning from Bottom Vertical Presentation Scanning from TopPlastic Top Plate Mounting RealScanRubber Feet Connect Power Cable and Interface Cable Vertical Mounting Bracket Cable Clamps Checkstand CutoutCheckpoint Cable Operating the Scanner Cleaning the Scanner Green Status Indicator Tones Problem Suspect Component Correcting Scanner ProblemsNCR RealScan 7882 Installation and Owner Guide Most Common Interface Cables Interface ConnectorInterface Information Protocol Communications ProtocolProgramming Worksheet Checkstand Hole RealScan 7882 Horizontal Mount NCR RealScan SpecificationsCheckstand Hole RealScan 7882 Flat Mount Ventilation Requirements Electrical WiringTone On/Off Programming WorksheetsPeriodical Codes Version DExtend UPC-A To EAN-13 Extend UPC-E To UPC-ATransmit Check Digit CodeMinimum Characters Allowed Full Ascii Check Digit PresentBar Code Type Minimum Data Characters Allowed UCCIdentifier Type Common ByteHandshake Baud RateParity Stop Bits Character LengthIBM Tone Control Good Read Tone Control Message DelayNormal or Eavesdrop Mode Terminator ByteAscii Code Chart Regulatory Information CE Mark Applicability Identification LabelsDeclaration of Conformity Laser Safety Label Laser SafetyLaser Module Label Laser PowerProgramming Tags Volume Adjustment ResetDefault Programming Mode End Save and Reset Abort Diagnostic Mode RS-232 Temporary Service Mode Mode Reset Tallies Hex Hex Hex Hex Hex Hex a Hex B Hex C Hex D Hex E Hex F Copyright 2001, 2002 by NCR Corporation