NCR 7882 manual Laser Module Label, Laser Power

Page 47

NCR RealScan 7882 Installation and Owner Guide

Laser Module Label

This laser module does not comply with 21CFR1040.

USE ONLY AS A COMPONENT.

18547

Laser Power

The NCR RealScan 7882 meets the following laser power requirements.

Class 1 EN 60825-1: 1994 (Europäische Norm)

Class 1 IEC 825-1: 1993 (International Electrotechnical Commission)

Class IIA CDRH (Center for Devices and Radiological Health) FDA, U.S.A.

Following is the radiant energy of the laser light as applied to each of the specified requirements.

Maximum Radiant Power (CDRH Calculation)

2.7 Microwatts

Maximum Radiant Power (EN 60825-1 / IEC Calculation)

0.82 Milliwatts

Accessible Emission Limit (CDRH Calculation)

3.9 Microwatts

Accessible Emission Limit (EN 60825-1 / IEC 825-1 Calculation)

0.80 Milliwatts

Warning – Use of controls or adjustments or performance of procedures other than specified herein may result in hazardous radiation exposure.

497-0419630 Release F

09/02

47 of 62

Image 47
Contents RealScan Installation and Owner Guide Revision Record ContentsObtaining Technical Assistance Obtaining Additional InformationRealScan RealScan 7882 MountingsStep Installation InstructionsConnecting the Cables to an NCR RealScan Installing Power Supply Interface CablesUSB Interface Connection IBM HID Auxiliary RS-232 Port Auxiliary RS-232 PortProgramming the Communication Parameters Setting Program Parameters and Verifying Host ConnectionTurning on the RealScan RS-232 NCR 2170, 7452 Ocia Short Format NCR 2113, 2126 RS-232 Ruby Verifone Ruby 4M UPC/EAN Programming DefaultsPrefix Byte Disable Ascii Code RS-232 Communications Programming for USB ConnectionMaking Other Program Changes UPC-A Scan Sample Tags1234 5 678 Determining Label QualityScan Zone Adjusting Screw Setting RealScan Scan ZoneVertical Pass-by Scanning Horizontal Pass-by ScanningVertical Presentation Scanning from Bottom Vertical Presentation Scanning from TopPlastic Top Plate Mounting RealScanRubber Feet Connect Power Cable and Interface Cable Vertical Mounting Bracket Cable Clamps Checkstand CutoutCheckpoint Cable Operating the Scanner Cleaning the Scanner Green Status Indicator Tones Problem Suspect Component Correcting Scanner ProblemsNCR RealScan 7882 Installation and Owner Guide Most Common Interface Cables Interface ConnectorInterface Information Protocol Communications ProtocolProgramming Worksheet Checkstand Hole RealScan 7882 Horizontal Mount NCR RealScan SpecificationsCheckstand Hole RealScan 7882 Flat Mount Ventilation Requirements Electrical WiringTone On/Off Programming WorksheetsPeriodical Codes Version DExtend UPC-A To EAN-13 Extend UPC-E To UPC-ATransmit Check Digit CodeMinimum Characters Allowed Full Ascii Check Digit PresentBar Code Type Minimum Data Characters Allowed UCCIdentifier Type Common ByteHandshake Baud RateParity Stop Bits Character LengthIBM Tone Control Good Read Tone Control Message DelayNormal or Eavesdrop Mode Terminator ByteAscii Code Chart Regulatory Information CE Mark Applicability Identification LabelsDeclaration of Conformity Laser Safety Label Laser SafetyLaser Module Label Laser PowerProgramming Tags Volume Adjustment ResetDefault Programming Mode End Save and Reset Abort Diagnostic Mode RS-232 Temporary Service Mode Mode Reset Tallies Hex Hex Hex Hex Hex Hex a Hex B Hex C Hex D Hex E Hex F Copyright 2001, 2002 by NCR Corporation