NCR 7882 manual Installation Instructions, Step

Page 5

NCR RealScan 7882 Installation and Owner Guide

Installation Instructions

When installing a RealScan 7882, it is recommended that you first mount the Power Supply and run all the cables. After connecting the unit to the host terminal, make any necessary programming changes and scan some good tags to verify that the scanner is communicating with the host terminal. After verifying that everything is working correctly, mount the unit in the checkstand. If the RealScan 7882 does not work properly, refer to the Correcting Scanner Problems section in this document.

The following flowchart shows the sequence of installation steps. Detailed descriptions of each step follow.

Step 1

Installing Power Supply and

Interface Cables

Step 2

Setting Program Parameters and

Verifying Host Connection

Step 3

Setting the Scan Zone

Step 4

Mounting the RealScan 7882

18682

497-0419630 Release F

09/02

5 of 62

Image 5

Contents RealScan Installation and Owner Guide Revision Record ContentsObtaining Technical Assistance Obtaining Additional InformationRealScan RealScan 7882 MountingsStep Installation InstructionsConnecting the Cables to an NCR RealScan Installing Power Supply Interface CablesUSB Interface Connection IBM HID Auxiliary RS-232 Port Auxiliary RS-232 PortProgramming the Communication Parameters Setting Program Parameters and Verifying Host ConnectionTurning on the RealScan RS-232 NCR 2170, 7452 Ocia Short Format NCR 2113, 2126 RS-232 Ruby Verifone Ruby 4M UPC/EAN Programming DefaultsPrefix Byte Disable Ascii Code RS-232 Communications Programming for USB ConnectionMaking Other Program Changes UPC-A Scan Sample Tags1234 5 678 Determining Label QualityScan Zone Adjusting Screw Setting RealScan Scan ZoneVertical Pass-by Scanning Horizontal Pass-by ScanningVertical Presentation Scanning from Bottom Vertical Presentation Scanning from TopPlastic Top Plate Mounting RealScanRubber Feet Connect Power Cable and Interface Cable Vertical Mounting Bracket Cable Clamps Checkstand CutoutCheckpoint Cable Operating the Scanner Cleaning the Scanner Green Status Indicator Tones Problem Suspect Component Correcting Scanner ProblemsNCR RealScan 7882 Installation and Owner Guide Most Common Interface Cables Interface ConnectorInterface Information Protocol Communications ProtocolProgramming Worksheet Checkstand Hole RealScan 7882 Horizontal Mount NCR RealScan SpecificationsCheckstand Hole RealScan 7882 Flat Mount Ventilation Requirements Electrical WiringTone On/Off Programming WorksheetsExtend UPC-A To EAN-13 Version DExtend UPC-E To UPC-A Periodical CodesMinimum Characters Allowed Full Ascii CodeCheck Digit Present Transmit Check DigitIdentifier Type Minimum Data Characters Allowed UCCCommon Byte Bar Code TypeParity Baud RateStop Bits Character Length HandshakeNormal or Eavesdrop Mode Message DelayTerminator Byte IBM Tone Control Good Read Tone ControlAscii Code Chart Regulatory Information CE Mark Applicability Identification LabelsDeclaration of Conformity Laser Safety Label Laser SafetyLaser Module Label Laser PowerProgramming Tags Volume Adjustment ResetDefault Programming Mode End Save and Reset Abort Diagnostic Mode RS-232 Temporary Service Mode Mode Reset Tallies Hex Hex Hex Hex Hex Hex a Hex B Hex C Hex D Hex E Hex F Copyright 2001, 2002 by NCR Corporation