Logging and Internal Trace Commands
SET LOG FILTER {EVENT DEBUG INFO SECURITY WARNING}
Specifies the type of information that is to be written to the event log. Use SHOW LOG to see the event log. Use SHOW LOG STATUS to see the current log filter.
ENABLE LOG MODULE <taskName ALL>
DISABLE LOG MODULE <taskName ALL>
Each firmware module issues status messages during operation. These commands enable or disable the inclusion in the event log of messages from the specified firmware module. Use SHOW LOG to see the event log. Use SHOW LOG STATUS to see which modules are currently excluded.
taskName | A module name (as seen in SHOW LOG). Examples: DHCP. |
|
|
ALL | Enable all module messages. |
|
|
ENABLE LOG OUTPUT REMOTE hostAddr
DISABLE LOG OUTPUT REMOTE
Enables/disables the sending of event log information to the specified device each time an event occurs.
hostAddr
IP address of the remote device (only required when enabling).
SHOW LOG [STATUS]
Displays the event log. SHOW LOG STATUS displays log status only.
START TRACE module [frame_size]
Starts a trace for the specified module. The optional ‘frame_size’ argument specifies the maximum size of one frame for that module. You can disable a trace with STOP TRACE.
STOP TRACE module
Disables a trace for a module. Traces are started with the START TRACE command.
SHOW TRACE module
Shows traces saved for the specified modules. Traces are started with the START TRACE command.
SHOW LOG PLUS module
Shows the log plus specified traces.
Command Line Reference | Page 77 |