3.2Internal Link LK13
Locate the internal connector LK13 on the motherboard (refer to Figure 9). This will be fitted with shorting links if the Echo LANlink was supplied without the Router Option. Remove the shorting links before fitting the Router Option. The links may be repositioned on one pin for storage.
3.3Installing the Router Option
Remove the option blanking plate above the CH 1 and CH2 connectors on the rear panel of the multiplexer. The blanking plate may be discarded if not required. The Router Option card should be carefully fitted in the position shown in Figure 10, connecting to J10 and J15 on the motherboard (refer to Figure 9). The Router Option power connector (flying lead) should be connected to J12 (ensure correct polarisation). Refit the rear panel screws to secure the option card
Router Option
J12
Figure 10 Echo LANlink showing Router Option Fitted
Echo LANlink Router Option User Manual | Issue 1.0 04 December 1997 Page 18 of 59 |