Echo EN55022 manual Download New Firmware using TCP loader, Download New Firmware using Tftp

Erasing Flash Memory

Programming Flash Memory

Verifying Flash Memory

Flash Memory OK

AN8100B Small Office Server Maintenance Menu Vx.x

1)Update Flash from Console port with Kermit

2)Update Flash from Ethernet with TCP Loader

3)Update Flash from Ethernet with TFTP Loader

4)Restore configuration from Ethernet via TFTP

6)Set new IP Address (xx.xx.xx.xx)

7)Set default Gateway (xx.xx.xx.xx)

8)Run Flash Program

9)Reset Password

B) Boot File using TCP Loader C) Boot File using TFTP Loader M)Run monitor

Enter Key:

Type in 8 to run the new revision of software.

I.2 Download New Firmware using TCP loader

This option is for factory use only.

I.3 Download New Firmware using TFTP

Selecting this option will allow the Manager to TFTP software upgrades to the Router. The Router will act as a server, enabling the files to be downloaded from the PC in Binary or Octet formats (not ASCII.)

I.4 Restore Configuration using TFTP

The configuration for Router is stored in the EEPROM. This configuration may also be saved to a PC. This must be carried out while the Router is operational (see the Security Section for set-up details.) Restoration must be carried out in the Maintenance mode.

Selecting this option will allow the Manager to TFTP to the Router a stored configuration. The Router will act as a server, enabling the files to be downloaded from the PC in a Binary or Octet formats (not ASCII.)

Echo LANlink Router Option User Manual Issue 1.0 04 December 1997 Page 57 of 59