I.5 Set New IP Address
Selecting this option will allow the Manager to set a new IP address for the Router if required to facilitate the file transfer. Note the burnt in MAC address will be used in the Maintenance mode.
I.6 Set Default Gateway
Selecting this option will allow the Manager to set a default gateway (should RIP not be transmitted) for the Router if required to facilitate the file transfer.
I.7 Run Flash Program
This will reboot the Router.
I.8 Reset Password
In order to give the network manager the ability to reset the Password on the Router the factory uses a unique system to reset the default password to SYSTEM. Using the number gives the user two minutes, and one attempt to reset the password to SYSTEM.
Type 9 and press <RETURN>
This will display:
Enter Key: 9
Unit Serial: ****
Enter Magic Number:
Type in the unique Magic Number supplied with the Router option, or a copy obtained from your distributor.
Press 8 <RETURN> to reboot the Router, and access the Security Menu to reset the password.
I.9 Boot File Using TCP Loader
This is for factory use only
Echo LANlink Router Option User Manual | Issue 1.0 04 December 1997 Page 58 of 59 |