4ROUTER MENU OPTIONS
The menu options allow the user to configure the router to individual requirements. The menu tree is shown in the diagram below, and each option is discussed in the following section.
Login Prompt
Unit Status
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Router |
|
| Multiplexer |
|
| System | |||
Management |
|
| Management |
|
| Status | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Traffic |
| Network |
| Remote |
| Unit |
| Service |
| Filter |
Analysis |
| Loading |
| Management |
| Configuration |
| Setup |
| Setup |
|
|
|
|
|
|
|
|
|
|
|
Events
4.1UNIT STATUS
This option displays statistics for the Ethernet and WAN links. At the top of the screen the unit name and time since power on are displayed.
The user can use the CLEAR option to reset the data counts to begin new analysis or EXIT option to leave the page.
The following table describes the parameters that are displayed:
PARAMETER | DESCRIPTION |
| OPTIONS |
NAME | Ethernet segment name | User defined | |
| WAN service name |
|
|
STATE | Port status for | the | ACTIVE |
| Ethernet Interface |
| FILTER |
|
|
| |
| Service status for WAN | LINK DOWN | |
| Interfaces |
| COMPRESSED |
|
|
| |
IP MODE | Current WAN IP routing | ROUTE | |
| status |
| BLOCK |
|
|
| BRIDGE |
IPX MODE | Current WAN | IPX | ROUTE |
| routing status |
| BLOCK |
|
|
| BRIDGE |
Echo LANlink Router Option User Manual | Issue 1.0 04 December 1997 Page 23 of 59 |