Power Connector Panel
power supply
retainer screw
power connector panel cables (5)
power connector panel
hook slots (4)
Figure 4-13. Power Connector Panel Removal (Nonredundant Systems)
To remove the power connector panel, follow these steps:
1.Disconnect the power supply from the power connector panel by sliding the power supply toward the back of the computer approximately
1 inch.
2.Disconnect all power connector panel cables (from the system board, the SCSI backplane board, and so forth).
3.Unscrew the retainer screw.
4.Disengage the panel from the four hooks holding it to the computer chassis, and then lift the panel away from the computer.