2.Keep the #2 Phillips screwdriver ready.
3.Follow the procedure listed in Before working inside your system.
4.Remove the mezzanine card. See Removing the mezzanine card.
Steps
1.Remove the two screws that secure the Network Daughter Card (NDC) to the system board.
CAUTION: To prevent damage to the NDC, you must hold the card only by its edges.
2.Lift the card from the system board.
Figure 19. Removing and installing the NDC |
|
| |
1. | slot on the NDC | 2. | screw (2) |
3. | NDC | 4. | standoff (2) |
5. | connector | 6. | tab projections |
Next steps
1.Install the NDC. See Installing the Network Daughter Card.
2.Install the mezzanine card. See Installing the mezzanine card.
3.Follow the procedure listed in After working inside your system.
64