CNet Technology CWR-800 manual

Page 10

3.Power on the cable or DSL modem.

4.Connect the power adapter to the Power port, and then plug the power adapter into a power outlet.

•The Power LED on the front panel will light up green as soon as the power adapter is connected properly.

4.Power on one of the PCs on your wireless network(s).

5.For initial access to the Router through a wireless connection, make sure the PC’s wireless adapter has its SSID set to CNET_Wireless (the Router’s default setting), and its WEP encryption is disabled. After you have accessed the Router, you can change the Router and this PC’s adapter settings to match the your usual network settings.

The Router’s hardware installation is now complete. Go to “Chapter 4: Configure the PCs.”

Image 10

Contents Broadband Router Table of Contents Introduction Static IP Addresses Dhcp Dynamic Host Configuration Protocol ServersWhat’s an IP Address? Dynamic IP AddressesPage Getting to Know the CNet Wireless-G Router LAN Indicators Over that portConnect the Router Page Page Configure the PCs Go to Configure the Router’s Basic Settings Go to Configure the Router’s Basic Settings Go to Configure the Router’s Basic Settings Configure the Router’s Basic Settings Page Static IP Address Dhcp Auto ConfigEnter the Default Gateway Enter the Internet IP AddressPPPoE Pptp Page Router’s Web-based Utility Internet Click More InfoDhcp Auto Config Static IP Address PPPoE Pptp Wireless Wireless Security WEP Wired Equivalent PrivacyWPA Wi-Fi Protected Access Setting WEP Pre-Shared Key Setting WPA RadiusPage Page Page Page Page Click Properties. You will see the following Click Setting Page Page WAN Page Page Page Page Access Control Page Port Mapping Application External Port TCP Protocol UDP Protocol SnmpPage Click the Delete This Entry button Dynamic DNS Page Transmit Power LED IndicatorsPower Dimensions