CNet Technology CWR-800 manual PPPoE

Page 18

F. Click the Apply button to save the settings, or click the Cancel button to clear the settings and start over. When you are finished, proceed to step 6.

PPPoE

If your DSL provider says that you are connecting through PPPoE (you use a user name and password to access the Internet), perform these steps:

A. Select PPPoE as the Configuration Type.

B.Enter the User Name.

C.Enter the Password.

Image 18

Contents Broadband Router Table of Contents Introduction Static IP Addresses Dhcp Dynamic Host Configuration Protocol ServersWhat’s an IP Address? Dynamic IP AddressesPage Getting to Know the CNet Wireless-G Router LAN Indicators Over that portConnect the Router Page Page Configure the PCs Go to Configure the Router’s Basic Settings Go to Configure the Router’s Basic Settings Go to Configure the Router’s Basic Settings Configure the Router’s Basic Settings Page Static IP Address Dhcp Auto ConfigEnter the Default Gateway Enter the Internet IP AddressPPPoE Pptp Page Router’s Web-based Utility Internet Click More InfoDhcp Auto Config Static IP Address PPPoE Pptp Wireless Wireless Security WEP Wired Equivalent PrivacyWPA Wi-Fi Protected Access Setting WEP Pre-Shared Key Setting WPA RadiusPage Page Page Page Page Click Properties. You will see the following Click Setting Page Page WAN Page Page Page Page Access Control Page Port Mapping Application External Port TCP Protocol UDP Protocol SnmpPage Click the Delete This Entry button Dynamic DNS Page Transmit Power LED IndicatorsPower Dimensions