CNet Technology CWR-800 manual LAN Indicators, Over that port

Page 7

WLAN Green. When Wireless network is active.

The LAN Indicators

LAN	Green. The LAN LED serves two purposes. If the LED is continuously lit, the
	Router is successfully connected to a device through the corresponding
	port. If the LED is flickering, the Router is actively sending or receiving data
	over that port.

The Internet Indicators

WAN Green. The WAN LED lights up when a successful connection is made between the Router and your cable or DSL modem (the Internet). The Link/Act LED flickers when the Router is sending or receiving data over the Internet port.

Proceed to “Chapter 3: Connect the Router.”

Image 7

Contents Broadband Router Table of Contents Introduction Dynamic IP Addresses Dhcp Dynamic Host Configuration Protocol ServersWhat’s an IP Address? Static IP AddressesPage Getting to Know the CNet Wireless-G Router Over that port LAN IndicatorsConnect the Router Page Page Configure the PCs Go to Configure the Router’s Basic Settings Go to Configure the Router’s Basic Settings Go to Configure the Router’s Basic Settings Configure the Router’s Basic Settings Page Enter the Internet IP Address Dhcp Auto ConfigEnter the Default Gateway Static IP AddressPPPoE Pptp Page Router’s Web-based Utility Click More Info InternetDhcp Auto Config Static IP Address PPPoE Pptp Wireless WEP Wired Equivalent Privacy Wireless SecuritySetting WPA Radius WPA Wi-Fi Protected Access Setting WEP Pre-Shared KeyPage Page Page Page Page Click Properties. You will see the following Click Setting Page Page WAN Page Page Page Page Access Control Page Port Mapping Snmp Application External Port TCP Protocol UDP ProtocolPage Click the Delete This Entry button Dynamic DNS Page Dimensions LED IndicatorsPower Transmit Power