CNet Technology CWR-800 manual

Page 9

4.Power on the cable or DSL modem.

5.Connect the power adapter to the Router’s Power port, and then plug the power adapter into a power outlet.

•The Power LED on the front panel will light up green as soon as the power adapter is connected properly.

6.Power on one of your PCs.

If you want to use a wireless connection to access the Router, follow these instructions:

1.Before you begin, make sure that all of your network’s hardware is powered off, including the Router, PCs, and cable or DSL modem.

2.Connect an Ethernet network cable from your cable or DSL modem to the Internet port on the Router’s rear panel. This is the only port that will work for your modem connection.

Image 9

Contents Broadband Router Table of Contents Introduction What’s an IP Address? Dhcp Dynamic Host Configuration Protocol ServersStatic IP Addresses Dynamic IP AddressesPage Getting to Know the CNet Wireless-G Router Over that port LAN IndicatorsConnect the Router Page Page Configure the PCs Go to Configure the Router’s Basic Settings Go to Configure the Router’s Basic Settings Go to Configure the Router’s Basic Settings Configure the Router’s Basic Settings Page Enter the Default Gateway Dhcp Auto ConfigStatic IP Address Enter the Internet IP AddressPPPoE Pptp Page Router’s Web-based Utility Click More Info InternetDhcp Auto Config Static IP Address PPPoE Pptp Wireless WEP Wired Equivalent Privacy Wireless SecuritySetting WPA Radius WPA Wi-Fi Protected Access Setting WEP Pre-Shared KeyPage Page Page Page Page Click Properties. You will see the following Click Setting Page Page WAN Page Page Page Page Access Control Page Port Mapping Snmp Application External Port TCP Protocol UDP ProtocolPage Click the Delete This Entry button Dynamic DNS Page Power LED IndicatorsTransmit Power Dimensions