CNet Technology CWR-800 manual Dhcp Auto Config

Page 23

1.Select Enable.

2.Enter your adapter’s MAC address in the MAC Address field.

3.To save your new settings, click the Apply button. To cancel your changes, click the Cancel button. To get more information about the features, click the Help button.

To disable MAC address cloning, keep the default setting, Disable.

DHCP Auto Config

By default, the Router’s Configuration Type is set to DHCP Auto Config, and it should be kept only if your ISP supports DHCP or you are connecting through a dynamic IP address.

To save your changes on this page, click the Apply button. To cancel any unsaved changes on this page, click the Cancel button. To get more information about the features, click the Help button.

Image 23

Contents Broadband Router Table of Contents Introduction Dynamic IP Addresses Dhcp Dynamic Host Configuration Protocol ServersWhat’s an IP Address? Static IP AddressesPage Getting to Know the CNet Wireless-G Router Over that port LAN IndicatorsConnect the Router Page Page Configure the PCs Go to Configure the Router’s Basic Settings Go to Configure the Router’s Basic Settings Go to Configure the Router’s Basic Settings Configure the Router’s Basic Settings Page Enter the Internet IP Address Dhcp Auto ConfigEnter the Default Gateway Static IP AddressPPPoE Pptp Page Router’s Web-based Utility Click More Info InternetDhcp Auto Config Static IP Address PPPoE Pptp Wireless WEP Wired Equivalent Privacy Wireless SecuritySetting WPA Radius WPA Wi-Fi Protected Access Setting WEP Pre-Shared KeyPage Page Page Page Page Click Properties. You will see the following Click Setting Page Page WAN Page Page Page Page Access Control Page Port Mapping Snmp Application External Port TCP Protocol UDP ProtocolPage Click the Delete This Entry button Dynamic DNS Page Dimensions LED IndicatorsPower Transmit Power