CNet Technology CWR-800 manual Dhcp Auto Config, Static IP Address, Enter the Internet IP Address

Page 17

DHCP Auto Config

If you are connecting through DHCP or a dynamic IP address from your ISP, perform these steps: A. Keep the default setting, DHCP Auto Config, as the Configuration Type.

B. Click the Apply button to save the setting, or click the Cancel button to clear the setting and start over. When you are finished, proceed to step 6.

Static IP Address

If you are connecting through a static or fixed IP address from your ISP, perform these steps: A. Select Static IP as the Configuration Type.

B. Enter the Internet IP Address.

C. Enter the Subnet Mask.

D. Enter the Default Gateway.

E. Enter the DNS in the 1, 2, and/or 3 fields. You need to enter at least one DNS address.

Image 17

Contents Broadband Router Table of Contents Introduction What’s an IP Address? Dhcp Dynamic Host Configuration Protocol ServersStatic IP Addresses Dynamic IP AddressesPage Getting to Know the CNet Wireless-G Router Over that port LAN IndicatorsConnect the Router Page Page Configure the PCs Go to Configure the Router’s Basic Settings Go to Configure the Router’s Basic Settings Go to Configure the Router’s Basic Settings Configure the Router’s Basic Settings Page Enter the Default Gateway Dhcp Auto ConfigStatic IP Address Enter the Internet IP AddressPPPoE Pptp Page Router’s Web-based Utility Click More Info InternetDhcp Auto Config Static IP Address PPPoE Pptp Wireless WEP Wired Equivalent Privacy Wireless SecuritySetting WPA Radius WPA Wi-Fi Protected Access Setting WEP Pre-Shared KeyPage Page Page Page Page Click Properties. You will see the following Click Setting Page Page WAN Page Page Page Page Access Control Page Port Mapping Snmp Application External Port TCP Protocol UDP ProtocolPage Click the Delete This Entry button Dynamic DNS Page Power LED IndicatorsTransmit Power Dimensions