CNet Technology CWR-800 manual Go to Configure the Router’s Basic Settings

Page 14

3.Make sure the box next to Internet Protocol (TCP/IP) is checked. Highlight Internet Protocol (TCP/IP), and click the Properties button.

4.Select Obtain an IP address automatically. Once the new window appears, click the OK button. Click the OK button again to complete the PC configuration.

Go to “Chapter 5: Configure the Router’s Basic Settings.”

.

Image 14

Contents Broadband Router Table of Contents Introduction Static IP Addresses Dhcp Dynamic Host Configuration Protocol ServersWhat’s an IP Address? Dynamic IP AddressesPage Getting to Know the CNet Wireless-G Router LAN Indicators Over that portConnect the Router Page Page Configure the PCs Go to Configure the Router’s Basic Settings Go to Configure the Router’s Basic Settings Go to Configure the Router’s Basic Settings Configure the Router’s Basic Settings Page Static IP Address Dhcp Auto ConfigEnter the Default Gateway Enter the Internet IP AddressPPPoE Pptp Page Router’s Web-based Utility Internet Click More InfoDhcp Auto Config Static IP Address PPPoE Pptp Wireless Wireless Security WEP Wired Equivalent PrivacyWPA Wi-Fi Protected Access Setting WEP Pre-Shared Key Setting WPA RadiusPage Page Page Page Page Click Properties. You will see the following Click Setting Page Page WAN Page Page Page Page Access Control Page Port Mapping Application External Port TCP Protocol UDP Protocol SnmpPage Click the Delete This Entry button Dynamic DNS Page Transmit Power LED IndicatorsPower Dimensions