Citizen Systems CLP-8301 user manual System Setup Menu

Page 52

Chapter 6 Configuring Your Printer Using the Menus

Horizont Shift

Inch mode

Shift	Shift	Shift
- 1.00IN	0.10IN	1.00IN

Metric mode

Shift	Shift	Shift
- 25.4mm	2.5mm	25.4m

6.3 System Setup Menu

The System Setup Menu provides access to configure the hardware settings within the printer such as the type of media sensor used and the threshold for gap detection, metric or imperial (inches) selection, print resolution and time and date setting, if a clock module is installed. It also allows for user access to the control panel and settings to be locked out to avoid inadvertent changes.

* System		System Setup Menu
* System
Setup

Media	Sensor	*	Sensor	Sensor	Sensor	Sensor	**
Sensor	See Thru		Notch	Reflec W	Reflec B	None

Sensor	Monitor
Monitor	1.3V 314
Sensor	Level	Level	Level
Level	0.0V	1.5V	3.3V

Top Form	Sensing	Sensing
Sensing	Yes/No	Yes/No

Key
Range	Toggle

Note: Menu Item on LCD with bold line is default.

Buzzer

Select

Metric/

Inch

(continued)

Buzzer	*	Buzzer	Buzzer	Buzzer	Buzzer	**
Exec/Err		All	Error	Key	None

Unit	Unit
mm/Inch	mm/Inch	* The last value (**) appears when DOWN
		* The last value (**) appears when DOWN
		key is pressed.
		** The first value (*) appears when UP key is
		pressed.

- 43 -

Image 52

Contents CLP-8301 Barcode Label PrinterPage EMI Compliance Statement For Canadian Users Important Safety Instructions Trademark Acknowledgement · Wide media, yet small installation space · Easy access to media and ribbon· Minimum maintenance · Easy operation control panelTable of Contents Configuring Your Printer Using the Menus Chapter TroubleshootingViii Chapter UnpackingPrinter accessories Safety Precautions ExamplesAvoid unsafe places Power cord Avoid high-humidity areas Loading the media and ribbon Installation precautions Names and Functions of Printer Parts Printer main bodyPrinter inside Rear and side of printer Control panel LCD DisplayKey functions in the Ready mode Key functions in the Menu mode Media Paper and Ribbon Types of media¨ Black mark tag ¨ Corner-with-a-radius cut tag= Label ¨ Black mark labelMedia size Loading media paper Roll mediaMedia Paper and Ribbon Path of inward-wound roll media Fanfold media Loading ribbon Flange aMedia Paper and Ribbon Media Paper and Ribbon Media Paper and Ribbon Ribbon tension adjustments Printhead adjustments Media sensor adjustments Media Paper and Ribbon Ribbon guide plate adjustments Media Paper and Ribbon Power on and Using the Control Panel Connecting to a power outletTurning the printer on 0000Ready Mode and Menu Mode ReadyReady mode Navigating the Menu SystemChanging Menu Values = Example changing the print densityPermanently Saving Printer Settings Producing a Test or Configuration Print = Example producing a test pattern printTurning the printer OFF Configuring Your Printer Using the Menus Group MenuSetup Menu DT/T TSystem Setup Menu System Setup MenuSTD/ALT After Print Menu Interface Setup Menu Permanently Saving Settings Menu Test Mode MenuMenu Mode Description STD Configuring Your Printer Using the Menus Troubleshooting Items to check in case of troubleTroubleshooting Error messages and corrective actions JamTroubleshooting Maintenance Printer careCleaning method Specifications General specificationsSpecifications InterfacesSerial interface XON/XOFF protocolDTR protocol Pin assignmentParallel interface Timing chart DataPrintable area Movable sensors FIX/VRPrinter operating conditions for ensuring print quality Environmental requirementsPrinter storage conditions Maintenance Citizen Systems Europe GmbH Mettinger Strasse