Chapter 4 Media (Paper) and Ribbon
7 The roll media is now loaded. Lastly close the top cover.
Fanfold media
1Remove ribbon holder disks (two) from the ribbon holder assembly. Place the paper holder shaft onto the round cuts on the paper guides and paper holder shaft supporting plates on both sides.
2Place the fanfold media on firm, level surface in the back of the printer and route it through the opening between top and lower bottom covers on the back of the printer, over the paper holder shaft and platen out to the top of the printer. Other loading procedures are same as for roll media (see
Paper holder shaft
- 22 -