American Megatrends MAN-STOR-ITX27-CLI manual Then, to enable the target, use the syntax below

Page 12

Then, to enable the target, use the syntax below:

CLI>enable –-type or –t tgt –-targetname or -n sanvol0 iscsi <Enter>

Example: enable –t tgt –n sanvol0 iscsi

Next step is to activate a port for iSCSI traffic.

CLI>activate	–-type or –t portal
	–-ipaddress	or	-p	10.0.0.100
	–-portaltag	or	-g	1 iscsi

Example: activate –t portal –p 10.0.0.100 –g 2 iscsi

We recommend that you assign different portal tags to the two portals if they are on different subnets.

6StorTrends® iTX Software CLI (Command Line Interface) (Version 2.7) User’s Guide

Image 12

Contents

MAN-STOR-ITX27-CLI 06/07/2010 Revision History Preface Table of Contents Limited Warranty Limitations of LiabilityTechnical Support Disclaimer Accessing CLI PrefaceOverview of CLI Initial Setup NIC-1Volume Configuration This will list the available RAID LD’s present in the systemPage Similarly a SAN volume can be created as follows To create a target, use the following commandsThen, to enable the target, use the syntax below Next step is to activate a port for iSCSI trafficCommand Set ChapterFor example To find out how the show command works, type CLIshow -h EnterAlert Configuration These commands configure the way alerts are generatedDate/Time Configuration Domain ConfigurationThese commands configure the time zone and date Event log Commands These commands display or clear the event logFirewall Configuration These commands configure the network firewall optionsGeneral Server Configuration Health ConfigurationThese commands get the health information ISCSI Configuration Command Argument Description License configuration These commands configure the LicenseNetwork Controller Configuration NAS Quota Configuration NAS User / Group Configuration List retrieved will be given for both instead of singlyFor exmaple set -t user -u test1 -p test1 -f Test1 ug Protocol Configuration RAID & Disk Management Commands Command Argument Description Upgrades the firmware for a Share, Directory & ACL Configuration These commands work on NAS shares and directoryLevel for NT System Control Configuration Volume and Snapshot CommandsThese commands configure the System controls 3provisiontype 0-ThinCommand Argument Description Command Argument Description UPS Configuration These commands configure the UPS for power managementXml For example update -l c0v0 -p 50 -m Syncreplica Synchronous replicationFor example For example Update -l c0v0 -p 50 -m 172.16.70.102 Update -l c0v0 -g rg0 syncreplicaThese commands configure asynchronous replication Asynchronous ReplicationUtilization bandwidth utilization Command Argument Description Failedduetorollback Command Argument Description Command Argument Description Command Argument Description Journal Volume Management These commands configure a journal and journal fileExample Example Get -t journalfile -c Cont0 -f jf0 journalPage Recovery Wizard These commands are to view cdp for journal fileThese commands are used as part of recovery wizard Continuous Data ProtectionThese commands are used as part of SRM Storage Resource ManagementList the tasks in report, pending Workflow queueThese commands are used as part of snap validation Local and Replicated Snapshot validationPage Appendix a Error Codes Code 175 Error in mounting the share 338 License file read write error Code Code Code Code Description Code Description Code Description