American Megatrends MAN-772 manual Attach Floppy Drive

Page 37

Step 8 Attach Floppy Drive

FLOPPY FLOPPY is a 34-pin dual-inline berg. Connect the cable from the floppy drive to FLOPPY, as shown below. The onboard floppy controller cannot be used if a hard disk card with a floppy controller is installed. Choose Standard Setup and Peripheral Setup to configure the floppy controller.

The motherboard supports up to two 720 KB, 1.44 MB, or 2.88 MB 3½" drives and 360 KB and 1.2 MB 5¼" drives. The connecting cable is a 34-pin ribbon connector with two 34-pin edge connectors for attaching the floppy disk drives. There is a small twist in the cable between the floppy connectors. The last (end) connector should be connected to floppy drive A:.

Cont’d

Chapter 1 Hardware Installation

33

Image 37

Contents Apollo IV Pentium PCI ISA MotherboardGuide Ii Apollo IV PCI Pentium ISA Motherboard User’s Guide Preface Phone Number CharacteristicsTechnical Support Static Electricity Packing ListCPU Manufacturer Supported CPU Speeds OverviewChipset Type of System Supported System Memory Socket Overview Ultra DMA/33 Fast ATAFloppy Parallel PortCPU External Clock Frequency PCI Expansion Slot Frequency MouseInfrared DMIMotherboard Height Restrictions Apollo IV DimensionsStep Action Installation StepsApollo IV Motherboard Layout Step Action Unpack the MotherboardSet Jumpers PWR1 Setting DescriptionFlash ROM Type Avoid Static ElectricityExternal Configure CPUP54C P55C ForP54C Summary of Jumper Setting for Intel Pentium CPUsSummary of Jumper Setting for AMD K5 and K6 CPUs Value Description AMD-K6 Step Action Supported System Memory Configurations Install MemoryType of System Memory Supported System Memory Socket Total SystemMemory Display Should supply these parts Install the MotherboardInstall Motherboard Attach Cables ConnectorAttach Cables Pin Description Power Connector PinoutPin MotherboardPin Description Connector Signal Descriptions Pins 12 13 14Connect Onboard I/O Pin Description Signal DescriptionSLCTIN# Pin Signal DescriptionAttach Floppy Drive Twist in Floppy Cable Floppy Connector PinoutPin Use Attach IDE Drive Attach IDE Drive Primary Pinout The Primary IDE pinout is Secondary IDE Pinout The Secondary pinout is Test and Configure Page Winbios Setup Using the Keyboard with Winbios Setup Using a Mouse with Winbios SetupKeystroke Action Winbios Setup Menu Drive Type How to Configure Standard SetupParameter Description 65535 1223 152 MB Hard Disk Drive TypesSetting Description Advanced SetupAdvanced Setup Type of Armd Device Drive Emulation Configured Advanced Setup Disabled Chipset Setup Power Management Setup Power Management Setup Cont’d PCI/PnP SetupSnoop Bit Action DMA Channel Option Optimal Default Fail-Safe DefaultPrimary Prefetch Peripheral SetupIDE Secondary IRQ options Offboard PCI IDE Primary IRQPeripheral Setup EPP Version Setting DescriptionSecurity Amibios Password SupportChanging a Password Setting a PasswordAnti-Virus Utility Optimal OriginalFail-Safe Programming the Flash Eprom Programming the Flash ROMStep Expected behavior Programming the Flash ROMNumber of Beeps Description Code Description Bootblock Code Checkpoint Codes