AMCC 9690SA manual Installing the Remote Battery, BBU control module connected to the controller

Page 24

Chapter 3. Installing a Battery Backup Unit

3Press down gently until the BBU is seated.

Figure 13. BBU control module connected to the controller

4Turn the controller over, insert the plastic screw head that you removed in step 1 into the plastic post, and tighten it gently but firmly. (Do not over-tighten!)

5If necessary, attach the extension cable to the BBU control module in order to reach the intended location of the remote battery board.

6Install your 3ware RAID controller. Refer to “Chapter 2. Installing Your 3ware RAID Controller” on page 11 for details.

Installing the Remote Battery

1Remove the metal filler brackets for the expansion slot in which you have decided to install the remote battery board.

Save the screws; they will be used to secure the remote battery board after you have installed it in the slot.

2If your enclosure is low-profile, unscrew the full height bracket from the remote battery board and replace it with the included low-profile bracket, using the same screws.

203ware 9690SA SAS/SATA RAID Controller Installation Guide

Image 24
Contents 3ware 9690SA SAS/SATA RAID Controller Copyright TrademarksDisclaimer Table of Contents About this Guide Contents of this Package Getting Started3ware 9690SA SAS/SATA RAID Controller Installation Guide 9690SA RAID Controller Card ModelsPort 3ware 9690SA-8I Serial ATA RAID Controller Cables Port 3ware 9690SA-8E Serial ATA RAID ControllerOther Available Cables Multi-lane Cable Serial ATA SFF-8087System Requirements Motherboard and Slot RequirementsOperating System Requirements Safety Information Site SelectionProtecting Equipment and Data Installation Considerations Tools You Need Before You StartInstall the Controller in the Computer Inserting Controller Into PCI Express Slot Attach the Cables to Your Controller Connect the Cables to Backplanes External Enclosure ConnectionFinishing Up the RAID Controller Installation Configure Your RAID ArraysConnect Battery if appropriate Check Installation and Close the CaseInstalling a Battery Backup Unit Items in Remote Battery Installation PackageInstalling the Control Module To install the control module Installing the Remote Battery BBU control module connected to the controllerThree locations for mounting battery on remote board Attaching the battery module to the remote board Installing the Remote Battery Replacing the Battery Removing the power cable from the BBU module 26 3ware 9690SA SAS/SATA RAID Controller Installation Guide Sales and ordering information Feedback on this manual
Related manuals
Manual 30 pages 1.85 Kb