AMCC manual Port 3ware 9690SA-8I Serial ATA RAID Controller

Page 7

9690SA RAID Controller Card Models

Figure 2. 8-Port 3ware 9690SA-8I Serial ATA RAID Controller

I2C connector

BBU connector and hole for post

Two internal Multi-lane connectors

Heat Sinks

Figure 3. 8-Port 3ware 9690SA-8IF Serial ATA RAID Controller

I2C connector

BBU connector and hole for post

I2C jumper 1

Two internal Multi-lane connectors

Buzzer Buzzer

Jumper

Heat Sinks

1Enables on board MUX if jumper is installed.

www.3ware.com

3

Image 7
Contents 3ware 9690SA SAS/SATA RAID Controller Trademarks CopyrightDisclaimer Table of Contents About this Guide Getting Started Contents of this Package9690SA RAID Controller Card Models 3ware 9690SA SAS/SATA RAID Controller Installation GuidePort 3ware 9690SA-8I Serial ATA RAID Controller Port 3ware 9690SA-8E Serial ATA RAID Controller CablesMulti-lane Cable Serial ATA SFF-8087 Other Available CablesMotherboard and Slot Requirements System RequirementsOperating System Requirements Site Selection Safety InformationProtecting Equipment and Data Installation Considerations Before You Start Tools You NeedInstall the Controller in the Computer Inserting Controller Into PCI Express Slot Attach the Cables to Your Controller External Enclosure Connection Connect the Cables to BackplanesCheck Installation and Close the Case Finishing Up the RAID Controller InstallationConfigure Your RAID Arrays Connect Battery if appropriateItems in Remote Battery Installation Package Installing a Battery Backup UnitInstalling the Control Module To install the control module BBU control module connected to the controller Installing the Remote BatteryThree locations for mounting battery on remote board Attaching the battery module to the remote board Installing the Remote Battery Replacing the Battery Removing the power cable from the BBU module 26 3ware 9690SA SAS/SATA RAID Controller Installation Guide Feedback on this manual Sales and ordering information
Related manuals
Manual 30 pages 1.85 Kb