AMCC 9690SA manual Attaching the battery module to the remote board

Page 26

Chapter 3. Installing a Battery Backup Unit

4Mount the battery in the selected location by snapping it in place.

a Insert the two clips on the top of the battery module into the two slots at the top edge of positions 2 or 3 (Figure 15), or in the holes at the left edge of position 1.

b Press down gently on the battery module until the bottom clip snaps into place in the lower hole.

Figure 15. Attaching the battery module to the remote board

Bottom clip will snap in here

9Insert the remote battery board in the chosen expansion slot and secure the bracket with the screw you removed in step 2. (Note that the remote battery board does not have a connector that inserts into a slot on the motherboard).

223ware 9690SA SAS/SATA RAID Controller Installation Guide

Image 26
Contents 3ware 9690SA SAS/SATA RAID Controller Disclaimer CopyrightTrademarks Table of Contents About this Guide Contents of this Package Getting Started3ware 9690SA SAS/SATA RAID Controller Installation Guide 9690SA RAID Controller Card ModelsPort 3ware 9690SA-8I Serial ATA RAID Controller Cables Port 3ware 9690SA-8E Serial ATA RAID ControllerOther Available Cables Multi-lane Cable Serial ATA SFF-8087System Requirements Motherboard and Slot RequirementsOperating System Requirements Safety Information Site SelectionProtecting Equipment and Data Installation Considerations Tools You Need Before You StartInstall the Controller in the Computer Inserting Controller Into PCI Express Slot Attach the Cables to Your Controller Connect the Cables to Backplanes External Enclosure ConnectionConnect Battery if appropriate Finishing Up the RAID Controller InstallationConfigure Your RAID Arrays Check Installation and Close the CaseInstalling a Battery Backup Unit Items in Remote Battery Installation PackageInstalling the Control Module To install the control module Installing the Remote Battery BBU control module connected to the controllerThree locations for mounting battery on remote board Attaching the battery module to the remote board Installing the Remote Battery Replacing the Battery Removing the power cable from the BBU module 26 3ware 9690SA SAS/SATA RAID Controller Installation Guide Sales and ordering information Feedback on this manual
Related manuals
Manual 30 pages 1.85 Kb