AMCC 9690SA manual Removing the power cable from the BBU module

Page 29

Replacing the Battery

Figure 17. Removing the power cable from the BBU module

Press down on the lever-like clip and pull the connector out.

3Remove the remote battery board from your system.

a Press down on the top of the battery module to free the clip on the bottom of the module.

b While pressing down on the top of the battery module, lift out the bottom of the battery module slightly.

c Once the bottom of the module is free, slide the module up to release the clips on the top.

Figure 18. Removing the battery module

2

2

3

3

1

 

 

 

 

2

 

3

 

 

 

1

 

 

 

 

 

1

 

 

 

3

 

Bottom clip

a)Push the battery module down gently.

b)Lift out the bottom of the battery module to release the clip on the bottom edge.

c)Lift up to remove the clips on the top edge.

www.3ware.com

25

Image 29
Contents 3ware 9690SA SAS/SATA RAID Controller Disclaimer CopyrightTrademarks Table of Contents About this Guide Getting Started Contents of this Package9690SA RAID Controller Card Models 3ware 9690SA SAS/SATA RAID Controller Installation GuidePort 3ware 9690SA-8I Serial ATA RAID Controller Port 3ware 9690SA-8E Serial ATA RAID Controller CablesMulti-lane Cable Serial ATA SFF-8087 Other Available CablesMotherboard and Slot Requirements System RequirementsOperating System Requirements Site Selection Safety InformationProtecting Equipment and Data Installation Considerations Before You Start Tools You NeedInstall the Controller in the Computer Inserting Controller Into PCI Express Slot Attach the Cables to Your Controller External Enclosure Connection Connect the Cables to BackplanesConfigure Your RAID Arrays Finishing Up the RAID Controller InstallationConnect Battery if appropriate Check Installation and Close the CaseItems in Remote Battery Installation Package Installing a Battery Backup UnitInstalling the Control Module To install the control module BBU control module connected to the controller Installing the Remote BatteryThree locations for mounting battery on remote board Attaching the battery module to the remote board Installing the Remote Battery Replacing the Battery Removing the power cable from the BBU module 26 3ware 9690SA SAS/SATA RAID Controller Installation Guide Feedback on this manual Sales and ordering information
Related manuals
Manual 30 pages 1.85 Kb