AMCC 9690SA manual Getting Started, Contents of this Package

Page 5

Chapter 1. Getting Started

The 3ware® 9690SA SAS RAID controller provides these features:

„Support for up to 128 SAS and/or SATA devices

„RAID 6 with simultaneous parity generation to maximize performance

„8th-generation StorSwitch™ switch fabric for maximum controller output

„StreamFusion™ optimization of RAID 5 and RAID 6 disk accesses to maximize application performance under heavy loads

„StorSave Battery Backup Unit (BBU) with write journaling to optimize data protection and performance (BBU must be purchased separately).

„RAID levels 0, 1, 5, 6, 10, 50, Single Disk, and Hot Spare

„PCI Express® x8 connectivity

Contents of this Package

If you purchased a full retail kit, the following items are included:

„One of the following 3ware 9690SA RAID controller cards:

„9690SA-4I (one internal 4x wide port)

„9690SA-8I (two internal 4x wide ports)

„9690SA-8E (two external 4x wide ports)

„9690SA-4I4E (one internal 4x wide port and one external 4x wide port)

„9690SA-8IF (two internal 4x wide ports)

www.3ware.com

1

Image 5
Contents 3ware 9690SA SAS/SATA RAID Controller Disclaimer CopyrightTrademarks Table of Contents About this Guide Getting Started Contents of this Package9690SA RAID Controller Card Models 3ware 9690SA SAS/SATA RAID Controller Installation GuidePort 3ware 9690SA-8I Serial ATA RAID Controller Port 3ware 9690SA-8E Serial ATA RAID Controller CablesMulti-lane Cable Serial ATA SFF-8087 Other Available CablesMotherboard and Slot Requirements System RequirementsOperating System Requirements Site Selection Safety InformationProtecting Equipment and Data Installation Considerations Before You Start Tools You NeedInstall the Controller in the Computer Inserting Controller Into PCI Express Slot Attach the Cables to Your Controller External Enclosure Connection Connect the Cables to BackplanesConfigure Your RAID Arrays Finishing Up the RAID Controller InstallationConnect Battery if appropriate Check Installation and Close the CaseItems in Remote Battery Installation Package Installing a Battery Backup UnitInstalling the Control Module To install the control module BBU control module connected to the controller Installing the Remote BatteryThree locations for mounting battery on remote board Attaching the battery module to the remote board Installing the Remote Battery Replacing the Battery Removing the power cable from the BBU module 26 3ware 9690SA SAS/SATA RAID Controller Installation Guide Feedback on this manual Sales and ordering information
Related manuals
Manual 30 pages 1.85 Kb