GLOBAL MODE
In Global Mode, you can send global messages and make general changes to the way that your MPK49 functions. Global Mode options are organized under different pages and include the list of options shown below.
NAVIGATING GLOBAL MODE
1.Press the [GLOBAL] button.
2.Use the [<] and [>] buttons to navigate through the available pages of options (shown below).
3.Use the [VALUE] dial to change settings, values or select a message on the selected page.
4.Press [ENTER] to accept the change or send a message or press [<]
| KILL MIDI | Send an All Notes Off or Reset Controllers message |
| Page 1 |
| |
| MIDI COMMON CHANNEL |
| Select which MIDI channel will be used as the |
| Page 2 |
|
|
| Common Channel. |
|
| ||
|
|
|
|
|
| |
| LCD CONTRAST | Adjust the contrast of the display. |
| Page 3 |
| |
| PAD SENSITIVITY | Adjust how sensitive the pads are to the touch. |
| Page 4 |
| |
| PAD VELOCITY CURVE |
| Adjust how the pads will output MIDI velocity, based |
| Page 5 |
|
|
| on the force applied to them. |
|
| ||
|
|
|
|
|
| |
| PAD THRESHOLD |
| Adjust the threshold of minimum force required to |
| Page 6 |
|
|
| activate a pad. |
|
| ||
|
|
|
|
|
| |
| KEYBOARD TRANSPOSITION | Transpose the keyboard up or down in semitones. |
| Page 7 |
| |
| MIDI CLOCK | Select Internal or External MIDI Clock source. |
| Page 8 |
| |
| TAP TEMPO AVERAGE |
| Select the number of taps to be averaged in |
| Page 9 |
|
|
| determining tempo. |
|
| ||
|
|
|
|
|
| |
| SAVE SETUP | Save the current global settings. |
| Page 10 |
| |
| SYSEX TX | Transfer a Preset via SysEx. |
| Page 11 |
| |
| VERSION | Check the current firmware version. |
| Page 12 |
| |
|
|
|
|
|
|
|
PROGRAM CHANGE MODE
A Program Change, often referred to as a Patch Change, is a MIDI message used for sending data to devices to cause them to change to a new program. This allows you to tell a hardware or software device which sound to play. For example, if your MPK49 is controlling a piano patch on your DAW or an external device, using a Program Change command allows you to easily switch to a synth patch.
NAVIGATING PROGRAM CHANGE MODE
1.Press the [PROGRAM CHANGE] button.
2.On Page 1, use the [VALUE] dial to select a Prog Change or Prog+Bank message on and press [ENTER].
3.On Page 2, use the [<] and [>] buttons to move through the different options and use the {VALUE] dial to change them.
4.Press [ENTER] to send the message.
There are two different types of Program Change messages on the MPK49:
PROG CHANGE – This event will transmit a regular Program Change message
PROG+BANK – This event transmits a Program Change message
12