American Dynamics KT-400 installation manual Optional Documentation

Page 36

Configuring the KT-400 Ethernet Four-Door Controller with the Web Configuration Page

This procedure is practical if you want to configure the KT-400 in advance before going on site.

Optional Documentation

Application Note, Networking Basics, DN1796.

Before you start

•The detachable Network Configuration Information Sheet is fully completed.

•Determine your connection to the KT-400 and choose the appropriate network cable that you need.

1.Make sure the KT-400 is in Forced Default Static mode before starting the configuration. Verify the heartbeat patterns to determine the status. See Table 3 on page 29 for details.

2.Start your web browser and enter the following IP: 192.168.1.2 and press Enter.

3.Put a jumper on JP3. Both jumpers should now be on JP2 and JP3.

4.Enter the IP addresses as per the Network Configuration Information Sheet and click on Save configuration to KT-400.

5.When you will go to the site with the configured KT-400, you will have to enter the same details into the EntraPass workstation.

32	DN1726-0811

Image 36

Contents KT-400 Page Table of Contents Installation Checklist Inputs and Outputs Assignments Sheet Pre-Installation Information Technical Support Compliance Specifications FCC & IC Compliance UL ComplianceUL 294 Compliance Notice UL 1076 Compliance NoticeDN1726-0811 Multiple Configuration Options OverviewInputs Trouble and Reporting KT-400 Ethernet Four-Door Controller PCB View KT-400 KT-400 Cabinet Model for North America System Architecture DN1726-0811 Over the internet with a KT-NCC and EntraPass Global Edition Vital LED Heartbeat Patterns Vital LED Heartbeat PatternsTechnical Specifications Type DescriptionElectrical Specifications TypicalExpansion Modules Models Related DocumentationDimensions Drawings Part number DescriptionMiscellaneous Items Models Information DN1762, FigureInstalling the KT-400 Ethernet Four-Door Controller Earth Grounding AWG #18 grounding wire to EgndConnect readers and keypads Reader Connection Terminal WarningTamper Protection Install tamper switch on cabinet Relay Controlled OutputsConnecting the KT-400 Ethernet Four-Door Controller BluePowering the KT-400 Ethernet Four-Door Controller Connecting over Corporate Network LANSPI Expansion Port Example of current draw calculationImportant Installation Rules about Expansion Modules KT-MOD-CAB Dimensions Drawing in DWG FormatPCB View of Expansion Modules With Expansion ModulesEthernet Four Expansion Modules Cabinet for North America Troubleshooting Soft ResetDefault initialization KT-400 Factory Default StepsBi-annual test for battery Annual test for emergency lithium ion batteryOptional Documentation Make sure the KT-400 is in Factory Default Dhcp mode. See on Important The KT-Finder application isVerify your Network Configuration Information Sheet KT-400 Ethernet Four-Door Controller EntraPass Site KT-400 Ethernet Four-Door Controller SiteInstallation Checklist Installing the KT-400 Ethernet Four-Door ControllerInputs and Outputs Assignments Sheet No or NC EOL, DRY or DeolKT-400 Cabinet Inner Door Sticker Diagram North America DN1726-0811