Netac Tech T610 user manual Check Configuration

Netac AirTrack T610 Wireless Broadband Router

mask is 255.255.255.0, please make sure that the configuration is correct, or obtain the correct parameter configuration from network manager.

b.Computer B (Wireless Network Interface Card user), please select the “Local Area Connection” opposite to Wireless Network Interface Card in figure 2.2, and configure it refer to the step as said.

2.3Check Configuration

Power on T610, the power indicator get bright, and T610 will self check about 30 seconds. T610 will detect all devices that connected to it. After self check, through observe the status of the LED that opposite to the 1# Ethernet port, you can distinguish whether the connection between Computer A and T610 successfully or not.

Also, you can check the status of Computer A and T610's connection by command ping as follows:

1.Click "Run" under the "Start" menu, input "cmd" in the pop-up dialog box, then press "Enter", as Figure 2.9.

Figure 2.9 "Run" dialog box

2.Input "ping 192.168.1.1" in the dialog box, press "Enter".

The following message indicates the connection successfully. "Pinging 192.168.1.1 with 32 bytes of data:

Reply from 192.168.1.1: bytes=32 time<10ms TTL=255"

8