Netac Tech T610 user manual LAN configurations

Page 29

Netac AirTrack T610 Wireless Broadband Router

Access Internet through ADSL Modem

Access Internet through Cable Modem/optic fiber

Access Internet through optic fiber

Figure 4.2 WAN configurations

•Configure LAN. Enter the LAN page, we suggest you to enable DHCP server, and configure start IP address and end IP address, such as: the start IP address is "192.168.1.2", the end IP address is "192.168.1.254". Also you can use default configuration without any change.

Figure 4.3 LAN configurations

24

Image 29

Contents Netac AirTrack T610 Wireless Broadband Router Remarks Radio Frequency Interference Remarks Page Table of Contents Introduction ChecklistWelcome Product functionStatus Description AppearanceConnecting Logging on configurationDefault ParameterConfigure TCP/IP Netac AirTrack T610 Wireless Broadband Router Netac AirTrack T610 Wireless Broadband Router Internet Protocol TCP/IP Properties setup Check Configuration Netac AirTrack T610 Wireless Broadband Router 12 detailed information Log on configuration14 logging 15 T610s configuration LAN Router ConfigurationField Description Radio SettingSecurity WAN WANSame subnet LANMAC Filter IP Filter DMZ Port ForwardReconfirm Password fields and click Apply AdminAssociation Table Build at-home network Mode of build networkLAN configurations Build network of enterprise Access Internet through Adsl Modem 10 Radio setting LED SpecificationsMy question is not included in FAQ, what shall I do? Appendix a FAQWhen shall I use DMZ? Appendix B Contact Netac Appendix C Glossary ISM band Infrastructure ModeMbps Wi-FiQoS RJ-45Wlan