Matsushita CF-08TX1A1M manual Preparations for backlight

■Preparations for backlight

Insert into the inside the ribs. (4 places in total)

LCD	LCD
	Prism Sheet
Panel Frame

wide side

LCD Panel Frame

For appearance standard information of the LCD process, refer to the "Common Assembly Instruction Manual".

LCD Prism Sheet

Remove the protection films. (both sides)		Holder Sheet
	LCD
			0~0.5mm
	Prism Sheet
Handle with care.
(Avoid fingerprints or scores.)			1

Holder Sheet

Attach two sheets.

	Details of "A"
	0~0.5mm
narrow side	Avoid
	running
	over the
	wall.
	0~0.5mm
A
Avoid running over the rib.		Tape
(both sides)

Insert into the inside the Hooks. (both sides)

Do not push or press the pull base.

	Reinforce Plate
Attach in the same way as 3.	Handle with care.
Symmetric shape
*Do not run over to the display side.	(Avoid fingerprints or scores.)

CCFL
	Safety Working
Refrecter	Avoid any stress when handling.
	(Handle with care not to break.)
	Do not fix the Cable at this point.
	(Note) Handle with care not to damage
	the light guide plate by using the Cable.

Light Guide Panel
Protection films is torn off.
(both side)
narrow side
Adhesive Tape S
Insert into the inside the ribs.	B
(4 places in total)

Light Guide Panel A

LCD FRAME

			Insert into the inside
			the Hooks.
DBEFD Sheet	Prism Sheet	wide side	(both sides)

thin line: white

Avoid running over the rib of the LCD Frame.

Reinforce Plate

thick line: pink

Details of "B"

Insert between 5 and LCD Frame on the opposite side

(6) as well..

After attaching to the light guide plate, put pressure of 20 to 30N(2.0 to 3.0 Kgf) on the Frame.

Details of "A"
Adhesive	Attach
Tape L	here.
	PET Tape
	(black side)
0~0.5mm

*Avoid running over the display side. (Handle 4 in the same way.)

9-7